1. Manuals
  2. Brands
  3. TIE Manuals
  4. Control Systems
  5. AMBITECH STAR-BRAKE
  6. Instructions manual

TIE AMBITECH STAR-BRAKE Instructions Manual

Motor starter and electronic brake
Hide thumbs
1
2
3
4
5
6
7
8

Advertisement

Table of Contents

STAR·BRAKE
Motor Starter · Electronic Brake
Instructions

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the AMBITECH STAR-BRAKE and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for TIE AMBITECH STAR-BRAKE

  • Page 1 STAR·BRAKE Motor Starter · Electronic Brake Instructions...
  • Page 2 Instructions Motor Starter • Electronic Brake CAUTION Disconnect and lock out power to Star-Brake Terminals 1, 2 and 3 before servicing.
  • Page 3 Table of Contents INTRODUCTION ........................... 1 DESCRIPTION AND APPLICATIONS ....................1 SAFETY NOTES ..........................1 LIMITATIONS ............................1 RATINGS .............................. 2 INSTALLATION ............................ 2 Mounting ............................... 2 Wiring ................................2 Control Wiring ............................... 2 Power Wiring ..............................2 6.4.1 Three Phase Motor .......................... 2 6.4.2 Single Phase Motor ..........................

  • Page 4: Description And Applications

    1. INTRODUCTION POWER LINE INTERRUPTION. The STAR-BRAKE uses AC line power to achieve its braking action. Thus a power failure or disconnect, or the opening of a fuse, will simply STAR-BRAKE serves as a complete motor control let the motor coast to a stop without braking. Do not use system for use with all single speed, single direction STAR-BRAKE where failure to provide braking will be a machines.

  • Page 5: Installation

    5. RATINGS Control Wiring should be used at its published 1. Connect a dry, momentary, normally closed (Stop) STAR-BRAKE horsepower rating. The protective overload is sized for pushbutton between Terminals S1 and S2. the nominal motor current, and may not protect a motor of lower horsepower.
  • Page 6 DIAL SETTING WITHIN A RANGE OF 5 TO 20 PERCENT OVER THE SETTING. IF THE OVERLOAD . TRIPS, WAIT 7 MINUTES AND RESET IT. STAR-BRAKE 7.2.2 Brake Adjustment NOTE: A red LED indicator on the circuit board is illuminated during braking. L2-- 1.

  • Page 7: If You Have A Problem

    Other parts of the STAR-BRAKE serve to control and 9. IF YOU HAVE A PROBLEM coordinate the action of the braking current, to form a complete braking system. These are described in the Preliminary Checks balance of this section. Check for possible damage in shipping, if so, notify the Detail Description freight carrier.
  • Page 8 Protect the internal components. They are of a Special fast-acting semiconductor-protecting type, and Aside from the above statement of warranty, TIE MUST be replaced with the same type of equal or Industrial, its agents, employees, dealers and Lower current rating.

Table of Contents