Advertisement
G. Installation steps of water pump
2. As shown in the figure, connect
1. As shown in the picture:
the water pump filter pipe and motor
prepare the backup pump.
As shown in the figure, insert
the air pipe vertically from the
outlet water joint of the pump.
H.
(Fig1)
3. As shown in the figure, the
4. As shown in the figure, put the spray-on
intermediate position of the
component of the replaced pump into the
motor pipe clip of the spray-on
water tank and insert the pump 4pin power
module with the perforated
connector from the wire pump connector
pipe shall be inserted.
(arrow pointing at arrow).
(Fig1)
5. Pump replacement is
completed as shown in the
figure.
Ver.: 190128
Advertisement
