Download Print this page

BestTrack Leveling Kit Quick Start Manual

For pinewood derby track

Download this manual

Thank you for purchasing the BestTrack

Please check out our web site at

products.

Please read through all of the instructions before starting to assemble your track.

BestTrack

By: SRM Enterprises, Inc.

P.O. Box 53

Forest City, IA 50436

Phone: 641-585-2299

Leveling Kit for your Pinewood Derby

www.besttrack.com

Slide the threaded U-clips onto the

leveling mounts snapping them in the

larger of the two holes. Thread a

leveling foot into the Threaded U-clip.

Starting with one section face down, remove

only the nut at one end of a connector

angle. Place the leveling mount over the

bolt and replace the nut. Be sure to position

the mount with the foot up as shown in the

picture. The leveling mount can be

positioned inboard or outboard on the track.

Repeat for the other three corners of the

track section.

Repeat these steps for all of the straight

sections including the stop section.

Pinewood Derby

for the latest information on new

Tracks

Track.

Updated 1/1/20

Page 1 P.O. Box 53 Forest City, IA 50436 Phone: 641-585-2299 Thank you for purchasing the BestTrack ® ® Leveling Kit for your Pinewood Derby Track. Please check out our web site at www.besttrack.com for the latest information on new products. Please read through all of the instructions before starting to assemble your track.
Page 2 Install leveling mounts with leveling feet at the bottom end of the curve section as you did with the straight section. Attach these at the bottom end of your curve section as in the previous section. Slide two Threaded U-clips onto the curve leg base so that they snap into the large holes at each end.