Advertisement
5 . CHANGING THE TOOL
CAUTION
Do not tighten the collet chuck without inserting a tool or dummy bur as this will result in damage
to the collet chuck.
RECOMMENDATION
Please minimize the tool overhang
amount to maintaining high accuracy.
① Set the provided 8mm wrench on the
Spindle.
② Place the provided 5.5mm wrench on the
chuck and turn it counter-clockwise to loosen
the collet chuck and remove the tool.
③ Clean the collet chuck, then insert the new
tool and tighten the collet chuck by turning
clockwise. Do not overtighten.
6 . REPLACING THE COLLET CHUCK
① Remove the tool according to the section
" 5. CHANGING THE TOOL " procedure
above (Fig. 3).
② Place the provided 8mm wrench on the spindle
shaft, and turn the top of the collet chuck
counter-clockwise to remove the collet chuck
(Fig. 4).
③ Install the new collet chuck into the Spindle
by turning it clockwise.
7 . INSTALLATION OF THE SPINDLE
WARNING
When installing a Spindle to a fixed base, make sure the fixed base is grounded in order to avoid
the risk of an electric shock.
CAUTION
・
When installing a Spindle, do not hit, drop or cause shock to the Spindle. This may cause
damage to internal components and result in malfunctions.
・
When mounting the Spindle, be sure to mounting within clamping area etched on the Spindle.
If the Spindle is installed incorrectly, this will cause and damage to the Spindle.
・
Cautions when tightening the securing bolt of the Split Type Holder
Do not over-tighten the bolt. This may cause damage to Spindle's precision.
Tighten the bolt until the Spindle body can not be turned by hand within the fixture.
Extreme tightening is not necessary or recommended.
Apply working force and check that the Spindle is tight before using.
4
Tool
Wrench 8mm
Spindle Shaft
Wrench 8mm
Collet Chuck
Wrench 5.5mm
Tighten
Fig. 3
Loosen
Collet Chuck
Spindle Shaft
Fig. 4
Loosen
Advertisement
