Advertisement
Advertisement
Table of Contents
Summary of Contents for Tru W-TX
- Page 3 CONNECTING: For best results use high quality, low impedance, shielded RCA connectors. For stereo inputs connect to the RCA Audio In jack. This can be connected to line level outputs on a source device such as a TV or AV receiver. When connecting an LFE or mono source, use the R channel of the Audio In RCA jack.
- Page 4 4. Press the “Pair” button on the back of the W-RX. A red light will begin to flash. 5. Within 10 seconds of pressing pair on the W-RX, power on the W-TX transmitter by plugging it into a wall outlet. Note: During the boot up process, the W-TX searches for the W-RX in pair mode and connects automatically.
- Page 6 1. Press the “Pair” button on the W-RX, until a red light starts to flash. 2. With the SLIM-PWR44 on and the blue light on, press the “Wireless Sub Pair” button once (located on the back of the SLIM-PWR44). You have sucessfully paired when the light on the W-RX turn to green.
Need help?
Do you have a question about the W-TX and is the answer not in the manual?
Questions and answers