PRESIDENT ADAMS FCC Owner's Manual page 8

4) DISPLAY
It shows all functions:
The BARGRAPH shows the reception level and the output power
level.
5) EMG ~ EMG SETTING ~ F
EMG
(short press)
Emergency channel is automatically selected when you press
EMG Key (5). "EMG" is displayed.
The default emergency channel is channel 9.
New short press in EMG key (5) to go back to the current channel.
"EMG" disappears.
EMG SETTING
Emergency channel can be set to any channel. To set a new
emergency channel :
Short press on EMG key (5) to call the current emergency channel.
-
"EMG" appears on the display.
Long press on F key (5).
-
blinks.
- Using the s/t keys (2), select the new emergency channel.
Press PTT switch (8) to validate and store the new emergency
-
channel. A validation beep sounds.
Notes: Emergency setting is not allowed if the current emergency
channel is not the active channel.
F
(long press)
See § F FUNCTIONS page 9.
appears on the display and "EMG"
6) CB/PA ~ NB
CB/PA
(short press)
Press CB/PA key (6) to alternate between
dress) mode. An external loud speaker can be connected to your
ADAMS FCC by the PA jack plug situated on the back panel PA.SP
(D). The CB message received or transmitted into the microphone
will be directed towards the external speaker and be amplified.
Adjust the PA volume with VOL key (1).
When PA mode is activated, "PA" and "AM" blink alternatively.
When PTT switch (8) is pressed, "PA" replaces the active channel on
the display. Release the PTT switch (8) to display again the active
channel.
NB
(long press)
Long press NB key (6) to activate/deactivate the Noise Blanker
filter. "NB" is displayed when NB filter is active.
NOISE BLANKER. This filter facilitates the reduction of back ground
noise, and some reception interference.
7) 4 PIN MICROPHONE PLUG
The plug is located on the front panel of the transceiver and makes
the setting of the equipment into the dashboard easier.
See cabling diagram page 45.
8) PTT (Push To Talk)
Transmission key, press to transmit a message,
release to listen to an incoming communication.
TOT (Time Out Timer)
If the transmission key is longer than 3 minutes, CHANNEL and
activated or deactivated
The time-out tone will sound until the PTT key is released.
A) DC-POWER TERMINAL (13.8 V)
B) ANTENNA CONNECTOR (SO-239)
8
CB PA
and (Public Ad-
is displayed and
start blinking, the transmission ends.