Seed 1dayPure moisture Instructions For Use

DESCRIPTION

SEED 1dayPure moisture shows spherical lens design and is available as a spherical lens for single vision.
SEED 1dayPure Multistage and SEED 1dayPure moisture FLEX show bifocal lens design and is available as an
aspherical bifocal lens.
SEED 1dayPure moisture for Astigmatism shows toric lens design and is available as an astigmatic (toric) lens for
single vision.
These lens materials are based on a 2-HEMA compound where positive and negative ions co-exist. The lens is
immersed in isotonic buffered saline with Polaxamer 407 and alginic acid.

INTENDED USE

Correction of vision

INDICATIONS

Spherical lens is indicated for myopia, hyperopia.
Aspherical bifocal lens is indicated for myopia, hyperopia, and presbyopia. Astigmatism (toric) is indicated for
myopia, hyperopia and astigmatism.

INSTRUCTIONS OF USE

These lenses are daily wear, daily disposable soft contact lens. Please wear lenses only while awake and remove
them before sleeping. Once daily disposable lenses have been removed from the eye, it must be thrown away.
・Instructions on handling lenses
1. Keep your fingernails short and smooth to avoid scratching your eye or your lenses.
2. Always wash your hands with soap and rinse carefully before handling your lenses. Lenses may become
contaminated if you do not wash your hands properly.
3. Always handle your lenses somewhere that is well-lit, clean and sterile.
4. Your contact lenses may become damaged depending on how you handle them.
・Checking the lenses and blister packaging
1. Check which lenses are for the right eye and which lenses are for the left eye.
2. Check if there is anything wrong with the lenses and blister packaging before opening. If there is anything
wrong, for example, if there is any damage or leakage, do not open and contact the point of purchase.
・Removing the lenses from the blister packaging
1. Break off the blister packaging by folding down the sides.
2. Remove the label, keeping a firm hold on the blister packaging and the label. When doing this, be careful not
to cut your hand on the blister packaging or label. Also note that the lens storage solution inside the blister
packaging may splash upon removal of the label.
3. Remove the lens from the blister packaging by sticking the lens to the pad of your index finger. Alternatively,
turn the blister packaging upside down and empty the lens together with the storage solution into the palm
of your hand. Take care, because if you dig your nail into the lens or scrape the lens on the rim of the blister
packaging on removal, the lens may be damaged.
・Checking the lenses
1. Hold the edges of the lens from the side and gently move up and down to remove the liquid.
2. Put the concave surface on the index finger of your dominant hand and check which the right and wrong sides
of the lens are. A lens has a right side and a wrong side.
Ensure that the lens is not inside out. Place the lens on your right index finger and verify the shape. (fig. 1
and 2)
YOUR EYES ARE PRECIOUS
Please read about your new contact lenses' Instructions for Use

IMPORTANT

fig. 1
SEED Co., Ltd.
fig. 2