Advertisement
ROLEX OYSTER WITH DATE FUNCTION
To change the time or date, or to wind the watch by hand, you must first unscrew the crown from
the case, then pull it until the required position is reached. Always perform these operations with the
watch in your hand and not on your wrist. When you are done, make sure the crown is screwed
down to the case again before you wear it.
Position 0
Position 1
Wearing position
Hand winding position
Crown fully screwed-down:
Only wear the watch when the crown is fully
screwed down to the case for it to be water and
dustproof. (although we would recommend to
prevent any contact with water. We do not
guarantee that the watch is waterproof.
Unscrew the winding crown
(downwards) till it is disengaged from
the screw thread:
For manually wound watches this position is
used to wind the watch by hand before you
wear it. (Don't wind it while on the wrist!) To
ensure long power reserve (one full day) make
sure you wind the crown upwards fully till the
crown can't go any further. This position can
also be used for automatic watches to give it a
boost of extra power, for example when the
watch hasn't been worn for some time.
Courtesy of Amsterdam Vintage Watches ™
Advertisement
Table of Contents
Summary of Contents for AW ROLEX OYSTER
- Page 1 ROLEX OYSTER WITH DATE FUNCTION To change the time or date, or to wind the watch by hand, you must first unscrew the crown from the case, then pull it until the required position is reached. Always perform these operations with the watch in your hand and not on your wrist.
- Page 2 Position 2 Setting time position Pull out crown after it is unscrewed: After unscrewing the crown to ‘position 1’, it can be pulled out. When this is done you can set the time by turning the crown in both directions. Upwards / clockwise: time goes forward.
Need help?
Do you have a question about the ROLEX OYSTER and is the answer not in the manual?
Questions and answers