Table of Contents
Advertisement
5 CALIFORNIA PROPOSITION 65
WARNING
This product contains a chemical known to the state
of California to cause cancer, birth defects or other
reproductive harm. Some dust created by power
sanding, sawing, grinding, drilling, and other con-
struction activities contains chemicals known to cause
cancer, birth defects or other reproductive harm.
Some examples of these chemicals are:
• Lead from lead-based paints;
• Crystalline silica from bricks and cement and other
masonry products;
• Arsenic and chromium from chemically
treated lumber.
Your risk of exposure to these chemicals varies
depending on how often you do this type of work. To
reduce your exposure to these chemicals, work in a
well-ventilated area, and work with approved safety
equipment, such as dust masks that are specially
designed to filter out microscopic particles.
6 EXAMINE THE LTV-CB CHARGING BASE
If the battery pack does not charge correctly:
1. Examine the current of the power outlet with different
machines. Make sure that the outlet works.
2. Examine that the charger contacts are not
short-circuited.
If the charger is not under usual room temperature,
move the charger and battery pack to a location
where the temperature is between 35˚F(2˚C) and
-100˚F(38˚C).
WARNING
If you put the battery pack into the charger in cold
or hot environment, the charger LED light is red.
Remove battery pack and allow temperature to
arrive at recommended charging range.
7 MOUNT THE LTV-CB
CHARGING BASE
1. Locate on wall where to
mount the charger.
2. Use 2 wood screws to attach
the charger on the wood
studs or anchors and screws
to mount to drywall.
3. Drill two paralleled holes
2 3/8" (60 mm) on center.
4. Use wall anchors and screws
to attach the charger to
the drywall. Hardware
not included.
8 OPERATION OF LVT-CB CHARGING BASE
CHARGE PROCEDURE
• Connect the plug of charger to an AC power outlet.
• Insert battery pack onto charger.
This is a diagnostic charger. The Charger LED Light
(3) illuminates in a specified order to show the
current battery status. They are as follows:
CHARGING PROCEDURE (LED INDICATOR)
BATTERY IS CHARGING
FULLY CHARGED
BATTERY IS TOO COLD/WARM
(REMOVE BATTERY AND
ALLOW TEMP TO ARRIVE AT
RECOMMENDED RANGE)
DEFECTIVE BATTERY (REMOVE
AND REPLACE WITH A NEW
BATTERY)
If you do not use the battery pack and charger for
a long time, please remove the battery from the
charger and unplug from power source.
9 MAINTENANCE
2-3/8 inch (60MM)
CLEANING THE MACHINE
Keep the air vent free of blockage, dust, and
debris. Do not spray, wash or submerge in water.
• Clear the unwanted material out of the air vent with
a vacuum.
• Clean housing and the plastic components with a
dry, soft cloth.
04
GREEN
BLINKING
GREEN
RED
RED
BLINKING
NOTE
NOTE
Advertisement
Table of Contents
