Door Opening; Putting Into Operation - Iarp GLEE 45 LITE User Instructions

Hide thumbs Also See for GLEE 45 LITE:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 15
Modello - Modèle - Model
Modell - Modelo
Fabbricante - Constructeur
Manufacturer - Hersteller
Fabricante
11

DOOR OPENING

Warning!
MAXIMUM ANGLE OF DOOR
OPENING = 140°
For correct working of the torsion bar and to avoid
any break of the door or of the hinge do not exceed
the maximum angle of door opening i.e. 140°.
12.

PUTTING INTO OPERATION

If the cabinet has been sharply tilted while being sited or for mounting of accessories, it must
be left to stand for at least three hours before being started to allow the lubricating oil to
settle in the compressor.
Failure to do so can cause total destruction of the compressor refrigerating system.
Check that the voltage on the identification plate is the same as that of the network.
THE ELECTRICAL SUPPLY LINE TO WHICH THE REFRIGERATOR WILL
HAVE TO BE CONNECTED IS TO BE PROTECTED BY A VERY SENSITIVE
DIFFERENTIAL SWITCH (Rc=16A,Dc=30mA); IT IS ALSO TO BE LINKED
TO THE GENERAL EARTHING PLANT.
Earthing is necessary and compulsory by law.
Absolutely never use reduction units, patch cords, adapters or multiple socket outlets
to connect the counter.
DIRECTLY connect the equipment to the mains.
The cable should be fully extended and located where it is unilikely to be struck, caught or
stepped on, away from water and the other liquids and heat sources and must not be damaged.
In case of breakage of the power cable of the cabinet, it must be replaced by the manufacturer
or by instruction it change of it.
Follow the manufacturer's instructions to install the unit, using qualified personnel and complying
with the electrical regulations for the specific country.
Incorrect installation may cause injury and damage; the manufacturer is not liable for this.
The manufacturer disclaims all responsability for any damage to people or things
due to incorrect observance of this rule.
GLEE 45 LITE
GLEE 45 PRIME
EPTA S.p.A. - Sede legale
Via Mecenate, 86 - 20138 Milano – Italy
Capitale € 68.515.000 - R.E.A./MI – 1730229
Registro delle Imprese e Cod.Fiscale n. 04160730968
Partita IVA 04160730968
2 3 / 7 2
PAGE
UM000326
N° DOC

Advertisement

Table of Contents
loading

This manual is also suitable for:

Glee 45 prime

Table of Contents