Connexion Of The Different Elements; Connection Of Cooking Zones; Combinations Of Cooking Zones - Foster 73 68 020 Installation Instructions Manual

CONNEXION OF THE DIFFERENT ELEMENTS

The installation of this appliance and the connections of the electrical network should be carried
out by a specialised technician in respect with the local norms and standards in use.

Connection of cooking zones

Each connector of each cooking zone, is identified by a sticker with a number from
5 to 8 which corresponds to the following:
 5: Heating zone 1100 W / Glass diameter 270mm (code 736127*)
 7: Heating zone 2300 W / Glass diameter 300mm (code 736230*)
 8: Heating zone 2300 W / Glass diameter 350mm (codice 736335*)
 The control panel is identified with the letter "C" on the connector
On the junction box, you can find the female connectors with the corresponding units: 5-6-7-8-
C.
The cords of the connector cables show the number for the correct connection to the induction
plates (see the below example 4 zones) Connect the heating zones with the corresponding
number of the junction box.
Connect the cable of the control panel to the "C" plug of the junction box.

Combinations of cooking zones

Touch control 2 zone: (product code 7369020)
- 2 remaining zones (induction plate code 5, 7, 8)
Touch control 3 zone: (product code 7369030)
- 1 zone 5 (mandatory) (induction plate code 736127*)
- 2 remaining zones (induction plate code 5, 7, 8)
Touch control 4 zone: (codice modello 7369040)
- 2 zone 5 (mandatory) (induction plate code 736127*)
-
2 remaining zones (induction plate code 5, 7, 8)
Example:
Nota: - It is strictly forbidden to lengthen or shorten the wires of the cooking zones.
- We do not take any responsibility in case the instructions contained in this
manual and/or safety norms are not followed properly.
13