Advertisement
1. Disconnect battery - negative cable first. DO THIS NOW!
2. Remove outer fairing.
3. Connect and mount the transmitter: one wire to ground and one wire to
switched 12V. Headlight high-beam circuit is best. (White wire on Harley
Davidson - Consult your shop manual).
4. Use zip-tie or Velcro to secure the CribClicker module.
1. Reconnect battery cables on bike - positive cable first.
2. Be sure area around garage door is clear. Connect power to garage door.
3. Connect and mount the transmitter: one wire to ground and one wire to
switched 12V. Headlight high-beam circuit is best. (White wire on Harley
Davidson - Consult your shop manual).
4. Test CribClicker by clicking switch from low to high to low and back to high.
After door operation, set switch back to low.
CribClicker is designed to work with almost every garage door and gate opener
on the market. There are however, some openers that may require use of an
external power adapter with your CribClicker receiver BT385 RX. You can obtain
an inexpensive power adapter from RadioShack (P/N 273-025 or 273-313 AC-to-
DC power adapter 6V 300 mA with tip set to negative). The purchase of a power
adapter includes choice of free tip - use White "N" tip. (Note: Power adapter is only
required if wall switch circuit voltage is less than 5 volts DC.)
Metal shielding (such as a headlight bucket) around the transmitter may decrease
effective system range. Position transmitter for acceptable performance.
1. Connect the receiver to a power source: either garage door or power adapter
mentioned in the troubleshooting section. Press and hold button on Receiver
until LED light turns on and then off – release button. The receiver is now in
pairing mode for the next 30 seconds.
2. Connect the Transmitter to a 9-volt battery. Open and close the circuit a few
times until the LED on the receiver flashes first dim, and then bright.
3. Wait 30 seconds for receiver to leave pairing mode. Connect Transmitter to
9-volt battery again and open and close the circuit. Receiver will flash LED once
and a click from the Receiver's internal relay switch will be heard.
Press and hold button on receiver. LED will flash once. Continue holding until LED
lights on a second time.
FCC Statement - This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular instal-
lation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equip-
ment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired opera-
tion.
Modifying or tampering with your Biketronics CribClicker BT385 can cause a malfunction, which might invalidate its warranty and void your
FCC authorization to operate it.
TRANSMITTER INSTALLATION
TEST AND FINISH
TROUBLESHOOTING
ADDING A TRANSMITTER
CLEARING RECEIVER MEMORY
Page 2 of 2
Updated 5-16-2013
Advertisement
