Congratulations on your Biketronics CribClicker
purchase! CribClicker is made in America using
components from American companies to the extent
possible and whenever available.
CribClicker is a state-of-the-art, highly secure
wireless garage door and gate opener. Should you
have questions regarding CribClicker, feel free to dial
the number found in these instructions.
When working on automatic garage door openers, make sure to follow the
manufacturer's safety instructions carefully. Please exercise good judgment.
Unplug the garage door motor when making connections.
Anticipate that opener may actuate at any time and use proper precautions.
1. Disconnect power from door/gate motor. DO THIS NOW!
2. Locate BT385 RX receiver on wall switch circuit between wall switch and door
motor. A good location is at door motor near the wall switch terminal strip. This
may be behind light-lens or on back of power door motor.
3. Use supplied Posi-Taps to make
connection of CribClicker's two black
wires to wall switch circuit, or
alternatively tap directly into the
terminal strip.
4. Use zip-tie or Velcro to secure the
CribClicker module.
Note: Yellow wire is the antenna and
should not be connected to anything.
You may lengthen this wire to
increase reception.
Contact Biketronics if you require assistance:
Tel: 800-735-2419
E-Mail: info@biketronics.com
Web: www.biketronics.com
CribClicker
Installation Guide
MADE IN USA
CAUTION!
RECEIVER INSTALLATION
Page 1 of 2
Universal Fitment
Features:
• Open your garage door by
fl ashing your high beams twice
• Highly secure wireless device
• Our Famous Lifetime Warranty
Watch the
installation video at
biketronics.com
or visit our YouTube
channel
Biketronics, Inc.
321 East Palouse River Drive
Moscow, ID 83843
BT385