Vision TriMax Carbon Clip-On Installation Instructions

Vision Clip-On Handlebar Installation Instructions
Published – May, 2021. ZS002.v9 © Full Speed Ahead
Introduction
Congratulations on your Vision product. Please read these instructions and follow them for correct use. Failure to follow
the warnings and instructions could result in damage to product not covered under warranty, damage to bicycle; or cause
an accident resulting in injury or death. Since specific tools and experience are necessary for proper installation, it is
recommended that the product be installed by a qualified bicycle technician. FSA & Vision assumes no responsibility for
damages or injury related to improperly installed components.
Warranty
Full Speed Ahead (FSA) warrants all FSA, Vision and RPM products to be free from defects in materials or workmanship for
a period of two years after original purchase unless otherwise stated in the full warranty policy. The warranty is
non-transferable and valid to the original purchaser of the product only. Any attempt to modify the product in any way
such as drilling, grinding, and painting will void the warranty. For more information on warranty policy and instructions for
completing a warranty claim, check out the Full Warranty Policy found at our website:
https://www.visiontechusa.com/en/technology
Always use a calibrated torque wrench to tighten all screws and bolts when assembling and adjusting the
vision handlebar to the bicycle. Failure to use a calibrated torque wrench can cause damage to the handlebar making it
unsafe to ride, and is not covered under warranty. Check bolt and screw torque before each ride to ensure they have not
loosened during use.
Periodically inspect your Aerboars for any cracks, chips, scratches, and any other visible damage. In the
event of an accident do not ride the bicycle until the handlebars have been inspected by an experienced mechanic as the
Aerobars may be damaged or weakened even if no visible damage is apparent. If there is any visible damage, the
Aerobars should not be used any further and replaced.
When changing the armrest Stack spacers ③, use the correct length bolt ⑥ as per the chart show in Table
1. Use only FSA supplied bolts. Failure to use the correct length bolt can result in thread strippage of the base bar, failure
of base bar, and armrest pad and can cause serious accident or injury.
Specification
These instructions are for the installation and adjustment of the following Vision Brand components only:
Model Name / Item Number TriMax Carbon Clip-On /HB-KO-a355Adj (V0125)
Model Name / Item Number TriMax Clip-On
Optional Replacement Parts
Optional Replacement Parts for Vision Clip-On Aerobars not included in the package. Replacment parts can be purchase
from FSA distributors or dealers.
Model Name / Item Number TriMax Carbon Armrest stack Spacer Kit / V0200
Components
Follow the assembly order in the illustration:
① Handlebar x1
② Aero Extension / Armrest Mount (L & R) x2
③ Stack Spacer (10 mm) x2
④ Arc Spacer x2
⑤ Lower Clamp plate x2
⑥ Aero Extension / Armrest Mount Bolts (35 mm) x4
Aero Extension (L & R) x2
⑦
/HB-RO-a356Adj (V0126)
⑧ Armrest Plates (L & R) x2
⑨ Armrest Pad x2
⑩ Aero Extension / Mount Fixing Bolts (16mm) x2
⑪ Armrest Plate Bolts x4
⑫ Aero Extension Front plug x2
⑬ Aero Extension Rear plug x2