Subscribe to Our Youtube Channel
Related Manuals for Ross Synergy Series
Summary of Contents for Ross Synergy Series
- Page 1 Ross Video Limited SERIES DIGITAL PRODUCTION SWITCHER Synergy Display Replacement Installation Guide...
- Page 2 Notice The material in this guide is furnished for informational use only. It is subject to change without notice and should not be construed as commitment by Ross Video Limited. Ross Video Limited assumes no responsibility or liability for errors or inaccuracies that may appear in this guide.
-
Page 3: Important Safety Instructions
Important Regulatory and Safety Notices to Service Personnel Before using this product and associated equipment, refer to the “Important Safety Instructions” listed here and in the front of the Vision Engineering Manual, to avoid personnel injury and to prevent product damage. Products may require specific equipment, and/or installation procedures to be carried out to satisfy certain regulatory compliance requirements. -
Page 4: Environmental Information
To avoid the potential release of those substances into the environment and to diminish the need for the extraction of natural resources, Ross Video encourages you to use the appropriate take-back systems. These systems will reuse or recycle most of the materials from your end-of-life equipment in an environmentally friendly and health conscious manner. -
Page 5: Package Contents
Package Contents The contents of the Synergy Display Replacement kit are listed below. If any items are missing, or damaged, contact Ross Video Technical Support. Part# Item 70-00124 Display 30-00104 3-Pin Display Power Connector Cap 4000ER-033-01 EEPROM U62, Issue 7... - Page 6 Synergy Display Replacement To install the new display in the control panel, you must power down the control panel and remove the old display, install the cap on the 3-pin power connector, and install the new display, and set the contrast for the new display. Once the new display has been installed, you must upgrade the EEPROM installed on the control panel CPU board.
- Page 7 Use a pair of small needle-nose pliers to disconnect the 3-Pin Display Power Cable from the power connector on the Function Switch Board. Remove the retaining screws from each corner of the display and put them in a safe place. You will need them to install the new display. Carefully remove the display from the inside of the control panel.
- Page 8 Control Panel EEPROM Upgrade To upgrade the EEPROM on the control panel CPU Board, you must open the CPU enclosure in the control panel, remove the old EEPROM, and install the new EEPROM in the same socket. Upgrading the Control Panel EEPROM To upgrade the EEPROM, you will need a DIP Extraction Tool and a Phillips screw driver.
-
Page 9: Setting The Display Contrast
Setting the Display Contrast The default contrast of the new display is different than the old display. When the new display is installed, you must adjust the contrast so that the menus on the display are visible. Press HOME More F6 (Setup) F1 (Display) (Large Display). - Page 10 Notes 10 • Setting the Display Contrast...
- Page 11 Notes Setting the Display Contrast • 11...
- Page 12 613 • 349 • 0006 613 • 652 • 4425 General Information solutions@rossvideo.com E-MAIL Technical Support techsupport@rossvideo.com 8 John Street, Ross Video Limited Iroquois, Ontario, Canada K0E 1K0 POSTAL SERVICE P.O. Box 880, Ross Video Incorporated Ogdensburg, New York, USA...
Need help?
Do you have a question about the Synergy Series and is the answer not in the manual?
Questions and answers