1. Manuals
  2. Brands
  3. Spyder Manuals
  4. Remote Control
  5. RF FOB
  6. User manual

Spyder RF FOB User Manual

Hide thumbs
1
2
3

Advertisement

Table of Contents

USER MANUAL FOR RF FOB
Label
RF FOB
IC: 10245A-BSSPWZIPA
FCC ID: OV9BSSPWZIPA

Important Information

FCC Notice to Users
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
(2) Spyder Controls has not approved any changes or modification to this device by the user. Any changes
or modification could void the user's authority to operate the equipment.
Industry Canada Notice to Users
This device complies with Industry Canada's license-exempt RSSs. Operation is subject to the following two
conditions:
(1) This device may not cause interference; and
(2) This device must accept any interference, including interference that may cause undesired operation
of the devices.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de
licence. L'exploitation est autorisée aux deux conditions suivantes:
(1) l'appareil ne doit pas produire de brouillage;
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d'en compromettre le fonctionnement.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the RF FOB and is the answer not in the manual?

Questions and answers

Summary of Contents for Spyder RF FOB

  • Page 1 (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. (2) Spyder Controls has not approved any changes or modification to this device by the user. Any changes or modification could void the user's authority to operate the equipment.
  • Page 2 RF FOB 8 button switch panel features an integrated 400 Mhz Transmitter that wirelessly sends messages to a receiver device. Each RF FOB has a green “Transmit LED” located at the center of the RF FOB. This LED should turn on whenever a button is being pressed or held, indicating that the RF FOB is transmitting.
  • Page 3 Troubleshooting If the RF FOB is not operating as expected, watch the Transmit LED and press one of the buttons to see if it comes on. If the LED does not come on, check the power source. Replace the CR2032 battery and try operating the RF FOB again.

Table of Contents