Kris Holm T-bar Handle Assembly Instructions

Download this manual

Introduction

The T-bar Handle improves riding comfort and control by reducing pressure at the front of the saddle. Elegant-

ly simple, lightweight and strong, it allows both angle and length adjustment. This lets you set your T-bar to the

ideal position for your riding style.

What's Included

The T-Bar handle requires assembly.

You will find the following parts included:

✔ Reinforcement plate

✔ Angles (2)

✔ Threaded inserts & M6x10 bolts with v

washers for the angles (2)

✔ Slotted tube

✔ T-bar (curved & straight versions)

✔ Bar ends (not shown)

✔ Six M5 x 25 mm bolts for attachment to the

saddle.

✔ "Seatpost" clamp for the slotted tube (not shown)

Assembling and Installing Your T-Bar Handle

ALL KH saddle models:

1. Remove the front saddle handle bolts. Remove the plastic handle if replacing it with the T-handle. Otherwise do not

remove the plastic handle.

2. Remove the front two seatpost plate bolts (curved saddles only). Do not remove the seatpost.

3. Place the reinforcement plate on the saddle. It may take some pressure to push it in place.

4. Place both angles on top of the plate so that they form a parallel slot.

5. Screw all bolts very loosely into the saddle frame. Then tighten all bolts to firm hand pressure.

6. Install the slotted tube between the angles. For more extended T-handle positions, face the seatpost clamp forwards.

For shorter T-handle extensions, face the tube clamp towards the rear.

7. Slide the brake lever onto the T-handle. Then slide the T-bar into the slotted tube and tighten with the tube clamp.

8. Once everything is assembled, adjust the angle and length. See the adjustment tips on the next page.

Special Instructions

Fusion One Saddle Model

1. Follow the same assembly instructions as above except: the rear of the reinforcement plate is fixed to the saddle with

a single bolt located in front of the Pivotal seatpost.

Fusion Zero Saddle Model (Discontinued)

1. Set aside the reinforcement plate. It is not compatible with this saddle.

2. If the front saddle handle is removed, place 4 thick plastic washers (included) under the angles.

3. Follow the same assembly instructions as above.

Page 1 of 2

REV: 05-2016 EN

T-Bar Handle Assembly Instructions

www.krisholm.com

Page 1 Introduction The T-bar Handle improves riding comfort and control by reducing pressure at the front of the saddle. Elegant- ly simple, lightweight and strong, it allows both angle and length adjustment. This lets you set your T-bar to the ideal position for your riding style.
Page 2 Use common sense, ride within your abilities, and wear safety gear. Kris Holm Unicycles cannot accept responsibility for any personal injury that you might sustain or that you might cause to another person as a result of the use, breakage or improper assembly of Kris Holm Unicycles equipment.