Electrical Shock Hazard - Thermador EXTNSET4 Installation Instructions Manual

Safety
DEFINITIONS
9 WARNING
This indicates that death or serious injuries may occur
as a result of non-observance of this warning.
9 CAUTION
This indicates that minor or moderate injuries may
occur as a result of non-observance of this warning.
NOTICE: This indicates that damage to the appliance or
property may occur as a result of non-compliance with this
advisory.
Note: This alerts you to important information and/or tips.
This THERMADOR
BSH Home Appliances Corporation
1901 Main Street, Suite 600
Irvine, CA 92614
Questions?
1-800-735-4328
www.thermador.com
We look forward to hearing from you!
Safety
9 IMPORTANT SAFETY
INSTRUCTIONS
READ AND SAVE THESE
INSTRUCTIONS
INSTALLER: Please leave these instructions with this unit
for the owner. Show the owner the location of the circuit
breaker. Mark it for easy reference.
OWNER: Please retain these instructions for future
reference.
Page. 1
®
appliance is made by
WARNING
If the information in this manual is not followed exactly,
fire or shock may result causing property damage or
personal injury.
WARNING
Turn off power circuit at service panel and lock out panel
before wiring this appliance. Allow the appliance to cool
after the power has been turned off before servicing the
appliance.
WARNING
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR
INJURY TO PERSONS, OBSERVE THE FOLLOWING:
• Use this unit only in the manner intended by the
manufacturer.
• Before servicing or cleaning unit, switch power off at
service panel and lock the service disconnecting
means to prevent power from being switched on
accidentally. When the service disconnecting means
cannot be locked, securely fasten a prominent
warning device, such as a tag, to the service panel.
WARNING

ELECTRICAL SHOCK HAZARD

• DO NOT remove connections.
• DO NOT use an extension cord.
• Improper grounding can result in a risk of
electric shock.
• Failure to follow these instructions can result
in death, fire, or electrical shock.
This appliance must be grounded. In the event of an
electrical short circuit, grounding reduces the risk of
electric shock by providing an escape wire for the electric
current.
Be sure your appliance is properly installed and grounded
by a qualified technician.
If required by the National Electrical Code (or Canadian
Electrical Code), this appliance must be installed on a
separate branch circuit.
To reduce the risk of fire or electric shock, do not use this
appliance with any solid-state speed control devices.
Installation, wire harness routing, electrical connections
and grounding must comply with all applicable codes. It is
the responsibility of the owner and the installer to
determine if additional requirements and/or local or other
codes apply to specific installations.