Table of Contents
Advertisement
Quick Links
HPS TruWave Active Harmonic Filter (AHF) Quick Start Instructions
These instructions will guide you through installing, testing your
installation, and starting up your AHF. For additional information
please refer to the owner manual provided with your AHF.
Disclaimer of Liability
The recommended practices in this manual are for general applications and are supplied without liability for errors or
omissions. Technical data are subject to change at any time without notice and any necessary corrections will be included
in subsequent editions.
Special requirements should be referenced back to the manufacturer and/or their representative.
The pictures used in this guide are only a representation and may vary from the actual product.
Literature No.: AHFQS
Issue Date: June 2020
Advertisement
Table of Contents
Summary of Contents for HPS TruWave
- Page 1 HPS TruWave Active Harmonic Filter (AHF) Quick Start Instructions These instructions will guide you through installing, testing your installation, and starting up your AHF. For additional information please refer to the owner manual provided with your AHF. The pictures used in this guide are only a representation and may vary from the actual product.
- Page 2 Electrical equipment should be installed, operated, serviced, and maintained, only by qualifi ed personnel. No responsibility is assumed by the manufacturer for any consequences arising out of the use of this material. HPS TruWave Active Harmonic Filter Quick Start Instructions...
- Page 3 Installation drawings. If using DO NOT press the “RUN” button on the display at this CTs supplied from HPS, the output wires of the CTs are time. If the display does not show anything, check to...
- Page 4 Your AHF also has the capability to automatically correct for certain incorrect CT placements, without rewiring or moving CTs. Refer to section 4.2.3. of the manual in order to use this feature. HPS TruWave Active Harmonic Filter Quick Start Instructions...
- Page 5 12. If the message “CTS ARE CORRECTLY POSITIONED” or “CTS ARE CORRECTLY ADJUSTED” is shown on the CT SETUP display, it is now time to enable the AHF to start correcting harmonics. Exit the CT SETUP display by pressing the MENU button in the bottom right corner of the display.
- Page 6 THDR% shown on any of the paralleled AHFs if all AHFs are operating and %LOAD values (see subsection 3.4.3 of the manual) for all paralleled operating AHFs add up to 100%. HPS TruWave Active Harmonic Filter Quick Start Instructions...
Need help?
Do you have a question about the TruWave and is the answer not in the manual?
Questions and answers