Advertisement
TECHNICAL SPECIFICATIONS
Call 01255 555200
Email info@durite.co.uk
Visit www.durite.co.uk
0-441-55 - LED Warning Lamp with STOP/TAIL Functions
DuriteWarning Light (AMBER) + STOP/TAIL (RED)
18W + 10W (6pcs*3W + 20pcs*0.2W)
Voltage: 10-30V DC
. Mounting: Surface mount
. Patterns: 10 flash patterns
. Waterproof Rate: IP67
. Highly increase the visibility of your vehicle during day and night to improve driving safety
E Mark R10, R65 and R7
THE TRUSTED QUALITY BRAND FOR PROFESSIONALS
Advertisement
Table of Contents
Related Manuals for Durite 0-441-55
Summary of Contents for Durite 0-441-55
- Page 1 TECHNICAL SPECIFICATIONS Call 01255 555200 Email info@durite.co.uk Visit www.durite.co.uk 0-441-55 - LED Warning Lamp with STOP/TAIL Functions DuriteWarning Light (AMBER) + STOP/TAIL (RED) 18W + 10W (6pcs*3W + 20pcs*0.2W) Voltage: 10-30V DC . Mounting: Surface mount . Patterns: 10 flash patterns .
-
Page 2: Safety Warning
WARNINGS Before using this unit please read these instructions carefully. Take special care to follow the warnings and safety suggestions listed below. Keep these instructions for future reference. SAFETY WARNING 1. Proper installation of this product requires the installer to have a good understanding of automotive electronics, systems and procedures. -
Page 3: Install Instructions
INSTALL INSTRUCTIONS Read all safety notes and mountng guidelines before installing the product. Verify that all parts listed under “In the Box” are present and complete. (Picture 1) Verify that all power supply comply to the specified voltage limits for the light. WIRING INSTRUCTIONS... - Page 4 FLASH PATTERNS If you want to set the flash pattern to synchronize, touch the red wire to the yellow wire for 1 second. This change the flash pattern. Note: If the light could not be synced please repeat STEP 1. Grouping for simultaneous flash: Connecting all units with black, red and yellow wires will synchronize all lightheads.
-
Page 5: Technical Specifications
TECHNICAL SPECIFICATIONS Call 01255 555200 Email info@durite.co.uk Visit www.durite.co.uk TECHNICAL SPECIFICATIONS Type Warning Lamp with STOP/TAIL Function Voltage 10-30VDC LED’s 6 WARNING, 20 STOP/TAIL Power 6 x 3W (WARNING) + 20 x 0.2W (STOP/TAIL) Current Draw at 12VDC Warning 1.12A, Stop 0.19A, Tail 0.029A.
Need help?
Do you have a question about the 0-441-55 and is the answer not in the manual?
Questions and answers