Advertisement
b
2
To continue assembly of the
CAGE UNIT, you will need
these pieces:
× 8
3
To attach the CAGE UNIT to
the STAND UNIT, you will
need the two completed units
with hardware:
× 4 sets
4
To install the COMPONENTS,
you will need these pieces:
F046 + F047 — 09 /16— A4
Align the extended wires along the back edge of the
roof panel with holes on the back panel frame, and the
extended wires along the side panels with holes on the
underside of the roof frame.
Attach the roof with two hex screws at the back corners.
WITH an assistant, the cage unit
and the stand unit can be assembled
together upright or laying flat.
WITHOUT an assistant, lay the
cage unit and the stand unit on
the floor.
Align the holes through the stand
unit with the holes through the
lower side panel on the cage unit.
Attach together with the hex screw/
nut pairs. Push the screw through
from the cage exterior and tighten
the nut from the cage interior.
Stand the cage upright.
Food/water cups:
Hook the cups onto the horizontal wire under
the snap-spring side doors.
Perches:
Install perches on a vertical wire, resting on a
horizontal wire for stability. Stagger perch place-
ment to allow birds to sit, fly, and move about.
Grille and Tray:
Rotate the windbell lock out of the way and
slide the grille into the top channel.
Slide the tray into the bottom channel.
Your Flight Cage is now fully assembled.
For more wonderful cages, toys, and accessories for dogs, cats, birds, chickens, rabbits, ferrets and small animals, visit www.prevuepet.com
If you have an assistant, have them hold the unit upright while you
align all extended wires of the roof/side panels with the holes on
the backside frame of the front panel. Double-check the alignment of
extended wires for the entire cage. Attach the front panel to the cage
with six hex screws.
Advertisement
