SETTINGS
_ _______________________________________________________________
Tuningandstoringradiostations
When the device is first connected to the mains or the
batteries are first inserted, the device begins an auto-
matic search and stores the first ten stations with strong
signals on the preset buttons 1,2,3,4,5. You can stop
this search by pressing »MEM.«.
However, you can also tune stations manually and store
them on the preset buttons.
1
Press »ON/OFF« to switch on the device.
– You will hear the radio station last selected.
2
Keep briefly pressing »–TUNING« or »
ING« until you have found the frequency you
want.
– Display: the frequency changes in steps of 50
kHz
or
TUNING« or »
Hold down
»–
approximately 1 second.
– Display: the automatic search stops at the next
station with a strong signal.
3
Briefly press »MEM.« to activate the memory func-
tion.
– Display: »M« flashes.
Note:
If you do not press any button within 3 seconds,
7
the device will quit memory mode without mak-
ing any changes.
4
Press the required preset button »1,2,3,4,5« (pre-
set stations 1 to 5).
– Display: e.g. »3«, »M« flashes
or
Press »+5« and the required preset button
3,4,5« (preset stations 6 to 10).
– Display: e.g. »8«, »M« flashes.
5
Press »MEM.« again to store the station.
– Display: the frequency, »M« and, for example
»3« or »8«.
Settingtheclock
When you first use the device, you first have to set the
clock.
1
2
+ TUN-
3
4
+
TUNING« for
Settingthealarmtime
1
2
3
»1,2,
4
5
6
With the device switched off, keep pressing
»MODE« until the time flashes in the display.
Note:
If you do not press any button within 3 seconds,
7
the device will quit set-up mode. Any altered set-
tings will be stored.
TUNING« briefly to set the hours step-
Press
»–
by-step or hold it down to run through the hours
quickly.
+
Press »
TUNING« briefly to set the minutes step-
by-step or hold it down to run through the minutes
quickly.
Press »MODE« to confirm the setting.
– Display: the current time.
Press »ON/OFF« to switch off the device.
– Display: the current time.
Press »MODE« briefly.
– Display: the alarm time most recently set, »
or »e« flashes.
Keep pressing »MODE« until the alarm time flash-
es in the display.
Note:
If you do not press any button within 3 seconds,
7
the device will quit set-up mode. Any altered set-
tings will be stored.
Press
»–
TUNING« briefly to set the hours step-
by step or hold it down to run through the hours
quickly.
+
TUNING« briefly to set the minutes step-
Press »
by-step or hold it down to run through the minutes
quickly.
Press »MODE« to confirm the setting.
– Display: the set alarm time, »
– After a short time, the display changes to the cur-
rent time.
§
«
§
« or »e« flash.
ENGLISH
15