Getting Started; Cleaning And Care; Troubleshooting - Emson RoboTwist User Manual

GETTING STARTED

BATTERY INSTALLATION
Note: Keep hands away from the Inner and Outer Jaws while installing batteries.
1. Press the gripping area at the side of the battery
door and pull it back. Insert 2 AA alkaline or
rechargeable batteries into the battery compartment
according to polarity. (Fig.1)
2. After installing batteries, replace the battery cover.
Note: Remember to always replace batteries at the
same time, never mix old and new types of batteries,
and never mix batteries of different types or quality.
USING YOUR AUTOMATIC JAR OPENER
1. Remove the paper or plastic neckband seal from
the Jar.
2. Move the rubber grip of the Outer Jaws all the way
down. (Fig.2)
3. With the Jar on a flat, not slippery surface, place your
Automatic Jar Opener evenly on top of the Jar.
4. Press and hold the Start Button. The outer Jaws will
begin to move in. Release the button when the Outer
Jaws pause and the Inner Jaws begin to move. (Fig.3)
Note: DO NOT put your fingers near or in the jaws
during the operation process. Press the Release
Button once to reset the unit.
Avoid contact with any of the moving parts during
operation. Keep hands, hair, jewelry, clothing and
utensils away from the moving parts to avoid injury
and/or damage to your Automatic Jar Opener.
3
Fig.1
Fig.2
Press 3 seconds and release
Fig.3
5. The Inner Jaws will grip the Jar Lid and then the Outer Jaws will resume their movement to hold the
Jar securely. Then the Inner Jaw will rotate to open the jar lid.
6. After opening the lid, the jaws of your Automatic Jar Opener will return to their original position and
stop automatically.
Note: To prevent toppling and spillage when opening small or tall jars, please secure the jar with one
hand and gently hold the Jar Opener Body with your other hand. Let the Jar Opener rotate until the
lid is open.
7. When the Jar Opener switches off, lift the Jar Opener off the Jar. Always ensure that the lid is
completely unscrewed from the jar by holding the jar with one hand while removing the lid with the
other hand.
8. To re-open a jar that has been stored in the refrigerator, wipe the moisture from the Lid and Jar
prior to using your Automatic Jar opener (Any moisture might cause the jaws to slip).

CLEANING AND CARE

1.Gently wipe surfaces with a clean, damp, soft cloth.
2.Use only gentle and non-abrasive cleaners on your Automatic Jar Opener.
3.DO NOT immerse the Jar Opener in water or any other liquids, as this may cause damage.

TROUBLESHOOTING

Problem
Jaws cannot grip the jar tight enough and
opener slips during operation
The Jar Opener lifts up when opening a
jar.
Solution
Use a dry cloth to clean the Lid, jar/bottle and
the Jar Opener's rubber grips
Press the main button fully for one second
during the operation to release the Jar Opener
and reset to its original position
4