Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for CF MOTO CF150T-6
Summary of Contents for CF MOTO CF150T-6
- Page 1 All manuals and user guides at all-guides.com...
- Page 2 All manuals and user guides at all-guides.com CF150T-6/CF150T-6A/CF125T-22/CF125T-22A is designed only for one driver and one passenger; the total load must be within the limit specified on the specification label. The scooter is designed only for on-road driving . Pay special attention to all the sentences or paragraphs marked with WARNING in this manual.
- Page 3 All manuals and user guides at all-guides.com Thanks for choosing the scooter CF150T-6/ CF150T-6A/ CF125T-22/ CF125T-22A. For safer and more pleasant driving, a complete understanding of all the instructions in this manual is necessary. Y our safety is not only ensured by your own alertness and your understanding of all operations but also related to your understanding of the mechanic performance of the scooter.
- Page 4 All manuals and user guides at all-guides.com...
- Page 5 All manuals and user guides at all-guides.com...
- Page 6 All manuals and user guides at all-guides.com A driver will always spend much time on learning driving methods and technique before driving on the highway in less traffic area. 1. Many accidents occur due to that automobile driver cannot see the scooter driver. Therefore, the scooter driver should make all his effort to be seen clearly by automobile driver.
- Page 7 All manuals and user guides at all-guides.com 1. Before starting the engine, please carefully inspect the scooter. (Refer to Page 17). 2. For safety, please wear helmet as well as boots, gloves, dust-tight glasses and noticeable clothing; 3. The top box or cargo box mounted by customer himself is for lightweight stuff only. If cargo boxes are mounted on both sides of scooters, please load equally on both and tight properly to avoid moving during driving.
- Page 8 All manuals and user guides at all-guides.com...
- Page 9 All manuals and user guides at all-guides.com Rear brake handle Instruments Fuel tank lock Fuel tank Trunk Battery Rear bracket Main stand Side stand Front turning signal (LH) The position marked with represents the invisible parts.
- Page 10 All manuals and user guides at all-guides.com Seat Ignition switch Front brake handle Headlight Front turning signal (RH) Front wheel Reservoir tank Rear wheel Muffler Taillight ASSY. The position marked with represents the invisible parts.
- Page 11 All manuals and user guides at all-guides.com Horn button Turning switch Turning reset switch High/low beam switch Kill switch Night switch Starting button...
- Page 12 All manuals and user guides at all-guides.com Fuel indicator Turning indicator (LH) High beam indicator Speedometer Speed digital indicator Parking indicator Turning indicator (RH) Water temperature indicator Engine oil indicator Odometer Clock indicator CF150T-6/CF125T-22 Instrument...
- Page 13 All manuals and user guides at all-guides.com Fuel indicator Turning indicator (LH) High beam indicator Speedometer Speed digital indicator Parking indicator Turning indicator (RH) Water temperature indicator Engine oil indicator Odometer Clock indicator Failure indicator CF150T-6A/CF125T-22A Instrument...
- Page 14 All manuals and user guides at all-guides.com Insert the key into the main switch to turn: ON, OFF or LOCK. 1. ON when turning the switch to the power is on engine can be started and the key cannot be taken out. 2.
- Page 15 All manuals and user guides at all-guides.com Fuel gauge is on the left side of the instrument panel which indicates the amount of the fuel in the fuel tank. The location F indicates that the amount of the fuel is full, and the location E indicates that the amount of the fuel will be used up, please refill immediately.
- Page 16 All manuals and user guides at all-guides.com CF150T-6A/CF125T-22A is equipped with fuel injection system. The failure indicator light is lower side of instrument panel. When the light flashes, it indicates the ECU failure, refer to attached table for details. Failure indicator light has two kinds of flash signals, long signal indicates tens digit , while short signal indicates...
- Page 17 All manuals and user guides at all-guides.com ERROR TYPE FLASH FAILURE DESCRIPTION ERROR-INJ-SC Short circuit of injector to battery positive terminal ERROR-INJ-OC Open circuit or short circuit to earth of Injector ERROR-IDLE-SC Short circuit of idle speed valve to battery positive terminal ERROR-IDLE-OC Open circuit or short circuit to earth of Idle speed valve ERROR-FANR-SC...
- Page 18 All manuals and user guides at all-guides.com Clock is in the lower of instrument. Open the seat, remove electric unit waterproof cover, and two adjust buttons can be seen. Clock adjust button (RH) will be used to adjust the hour in clock, while button (LH) to adjust the minute.
- Page 19 All manuals and user guides at all-guides.com There are three switches on left handlebar switch 1. Beam switch The beam switch has two positions press to this position the high beam is on; press to this position the low beam is on. 2.
- Page 20 All manuals and user guides at all-guides.com 1. The illumination switch consists of three positions when the switch is at this position headlight, the pilot light, taillight and instrument light are when the switch is at this position, the pilot light, taillight and instrument light are on When the switch is at this position, headlight, the pilot light, taillight and instrument light are off.
- Page 21 All manuals and user guides at all-guides.com Insert the key into the lock at the left side of the seat and turn the key clockwise to open the seat. 1. Open the seat and the trunk will be opened. Raincoat, tools, books and some newspapers can be put in.
- Page 22 Once the fuel is insufficient, please refill the fuel tank in time. (Refer to fuel gauge on Page 10). Fuel tank capacity 8.0 L CF150T-6/CF125T-22 7.5 L CF150T-6A/CF125T-22A Turn the dust cap on the fuel tank cover, insert the key into the lock and turn the key clockwise, remove the fuel tank cover, and then refill fuel.
- Page 23 All manuals and user guides at all-guides.com 1. Park the scooter on a level surface and support it with its central stand. Remove the oil dip rod and clean it with a rag. Insert the oil dip rod without screwing tight. Remove again and check oil level. 2.
- Page 24 All manuals and user guides at all-guides.com Check the brake fluid level: Brake fluid should be above the LOWER mark. Brake lever free play : 10~30mm (at brake lever end) Replace the front and rear brake disk if the thickness is less than 3mm.
- Page 25 All manuals and user guides at all-guides.com This scooter is assembled with tubeless tires. Only tires marked with TUBELESS TIRE APPLICABLE can be used. Proper tire pressure will provide you with maximum stability, comfort riding and longer tire life. Please check the tire pressure periodically and adjust if necessary.
- Page 26 All manuals and user guides at all-guides.com When the tread height of the tire reaches the mark , the tire should be replaced.
- Page 27 All manuals and user guides at all-guides.com Hold the rear brake lever to lock the rear wheel. Insert the key into main switch, and turn to Turn kill switch to Return side stand Press start button to start the engine...
- Page 28 All manuals and user guides at all-guides.com 1. Push the scooter forward and the main stand returns. 2. Sit on the seat with right foot on the footrest and left foot on the ground. 3. Release rear brake lever;...
- Page 29 All manuals and user guides at all-guides.com 4. Increase throttle slowly, and the scooter will start to run. 5. Turn or release throttle for acceleration or deceleration. 1. Throttle down Throttle down to lower the speed, and it is important to engage the front and rear brake simultaneously.
- Page 30 All manuals and user guides at all-guides.com 2. Engage the front and rear brake simultaneously. When driving down a steep slope, release the throttle, and engage the front and rear brake simultaneously. Don t b rake c ontinuously; o therwise t he b rake w ill b e o verheated w hich w ill r esult i n l ower b rake e fficiency. When you want to park the scooter, release the throttle, then engage the front and rear brakes simultaneously till the scooter is stopped.
- Page 31 All manuals and user guides at all-guides.com 3) If possible, park the scooter in the garage. 4) Use high quality anti-theft device. The maintenance interval is based on the accumulated mileage and is the guideline for maintenance and lubrication of the scooter. The maintenance interval shall be shorter if the scooter always works in foul conditions at high speed.
- Page 32 All manuals and user guides at all-guides.com Odometer reading (KMS)/month (1) Interval which occurs first Perform the instructions in the Inspection Before Item 4000/ 8000/ 12000/ 1000 Page Driving section (Refer to P17) prior to each 6000 12000 18000 Fuel pipe periodical maintenance.
- Page 33 All manuals and user guides at all-guides.com Air cleaner is located up under the seat. 1. Remove air cleaner bolts 2. Remove top cover 3. Take out air cleaner filter element 4. Clean filter element with non-combustible or high flash point solvent, and then air-dry it.
- Page 34 All manuals and user guides at all-guides.com Radiator is located in middle part of front foot deck. Clean dust and mud from the radiator periodically according to the road condition. Only use the high quality Ethylene Glycol based antifreeze with erosion inhibitor, which is special for aluminum engines.
- Page 35 All manuals and user guides at all-guides.com High quality engine oil is of ideal performance. Only high quality scooter engine oil SE or SF Grade with high de-pollution performance can be used. No additive is needed. SE Grade SAE10W-30 SAE15W-40 SF Grade SAE20W-50 The viscosity of the engine oil shall be in accordance with...
- Page 36 All manuals and user guides at all-guides.com First filling: 0.9L Replacing: 0.85L Replacing interval: First time at 500kms, then every 3000kms Park the scooter with main stand and replace oil when the engine is still warm for complete drainage of the used oil. 1.
- Page 37 All manuals and user guides at all-guides.com Recommended gearbox oil type: SAE10W-30/SE 1. Park scooter with main stand. 2. Remove the filling bolt and drain bolt 3. Clean drain bolt, install and tighten it. 4. Fill gear oil through the filling hole till it overflows. 5.
- Page 38 Bend the side electrode to adjust the gap to 0.8mm~1.0mm. The gap should not be too small. Battery type 12V7Ah CF150T-6/CF125T-22 12V10Ah CF150T-6A/CF125T-22A Open the seat, remove electric unit waterproof cover, and battery can be seen. Loosen the...
- Page 39 All manuals and user guides at all-guides.com The main fuse is located on the starter relay under the seat on left lower side of electric unit waterproof cover, with rated current capacity of 20A. Remove starter relay coupler, and you will see it. Fuse box is located on the electric unit waterproof cover under the rear seat.
- Page 40 All manuals and user guides at all-guides.com The tools are in the compartment below the seat. These tools are enough for minor repairing, adjusting or part replacing. The tool kit includes: 8 10mm open end wrench 12 14mm open end wrench 13 15mm open end wrench S=5 internal hex wrench Double-end screwdriver...
- Page 41 All manuals and user guides at all-guides.com The serial number of the frame and the engine are used for registration, applying driving license and ordering parts. When order or replace some parts, above numbers should be supplied. The frame number (VIN) is under trunk, remove VIN plate cover, and it can be seen.
- Page 42 All manuals and user guides at all-guides.com If the scooter will be stored for a long time, such as in winter, necessary measures shall be taken to prevent damage or malfunction of parts. In addition, some repairing is necessary. 1. Replace the engine oil and the oil screen. 2.
- Page 43 All manuals and user guides at all-guides.com 1. Remove the scooter cover and wipe it clean. If the scooter has been stored for more than 4 months, replace the engine oil. 2. Check the electrolyte s l evel. C harge t he b attery, i f n ecessary. 3.
- Page 44 0.8~1.0 mm Net Weight 138 kg Front 100/80-14 M/C 48L Engine oil Crankcase0.9L, Gearbox0.15L Rear 120/80-14 M/C 58L Fuel tank (CF150T-6) 8.0 L 7.5 L Fuel tank (CF150T-6A) Max. Power (CF150T-6) 8.3 kW/7500 r/min Max. Load 150 kg Max Power (CF150T-6A) 8.1 kW/8500 r/min...
- Page 45 All manuals and user guides at all-guides.com Fuel consumption 2.5 L/100km Fuse 20A/10A/5A 1600 160 r/min 12V 10W 2 Idle speed (CF150T-6) Turning signal F Idle speed (CF150T-6A) 1700 170 r/min Turning signal R 12V 10W 2 Instrument 12.10 Final reduction ratio...
- Page 46 All manuals and user guides at all-guides.com Single cylinder, liquid cooled, Type 4 stroke, horizontal Length 1950 mm Bore Stroke 52.4 57.8 mm Height 1195 mm Compression Ratio 11 1 Width 715 mm Displacement 124.6 ml Wheel base 1320 mm Type Ground clearance 130 mm...
- Page 47 All manuals and user guides at all-guides.com Fuel consumption 2.5 L/100km Fuse 20A/10A/5A 1600 160 r/min 12V 10W 2 Idle speed (CF125T-22) Turning signal F Idle speed (CF125T-22A) 1700 170 r/min Turning signal R 12V 10W 2 Instrument 12.10 Final reduction ratio Turning signal indicator High/Low beam indicator Battery CF125T-22...
- Page 48 All manuals and user guides at all-guides.com...
- Page 49 All manuals and user guides at all-guides.com...