Advertisement
Quick Links
1. Exterior Parameters
Casing Material: ABS
Display Material: High Hardness Acrylic (the same hardness value as tempered
glass).
www.czfound.com
www.foundmotor.com
LCD Display S-886
User Manual V.2018
（for electric scooter only）
Front View
1
info@czfound.com
info@foundmotor.com
Advertisement
Summary of Contents for FM S-886
- Page 1 LCD Display S-886 User Manual V.2018 （for electric scooter only） 1. Exterior Parameters Casing Material: ABS Display Material: High Hardness Acrylic (the same hardness value as tempered glass). Front View www.czfound.com info@czfound.com www.foundmotor.com info@foundmotor.com...
-
Page 2: Side View
Side View Thumb Throttle 2. Operating Voltage and Connections a. Operating Voltage: DC24V / 36V Compatible, 36/48V Compatible (set by the control Display). Other operating voltage can be customized. b. Connections: Standard connector sequence www.czfound.com info@czfound.com www.foundmotor.com info@foundmotor.com... - Page 3 Controller Connector Display End (Waterproof) Controller End (Waterproof) Standard Connector Sequence Table Sequence No. Wire Colour Functions Red（VCC） Display Power Cord Blue（K） Controller Power Cord Black（GND） Display Ground Wire Green（RX） Display Data Receiving Wire Yellow（TX） Display Data Sending Wire Note: Some products come with waterproof connectors, whose internal wire colors cannot be decided from outside.
- Page 4 Interface Instruction 3.1 Battery Level 3.2 Multi-Function Display Total Mileage: ODO (km or mile) Single Mileage: TRIP Rest Mileage: RM (software support of battery protection board needed) Operation Time: TM Error Code: ERR 3.3 Error Code Error Indications Note Code (decimal) Normal Reserved...
- Page 5 Brake PAS Sensor Failure (riding mark) Not Realized 6km/h Cruise Real-Time Cruise Low Battery Motor Failure Throttle Failure Controller Failure Communications Receiving Failure Communications Sending Failure BMS Communications Failure Light Failure 3.4 Speed Display Measuring Unit: mph or km/h The Display will calculate the actual travelling speed based on the wheel diameter and signal data (number of magnet steel is needed for motors with Hall sensors).
- Page 6 When the current speed exceeds the speed limit, the PWM output will be shut down; when the current speed falls to lower than the speed limit, the PWM output will be activated and the driving speed will be set as the current speed ± 1km/h (only applies to assist power speed, not applicable to the handlebar speed).
- Page 7 3. Long press to enter the setting menu. At the setting interface, short press to adjust parameters. Long press switch the value increase/decrease function of this key Change parameter value: Short press to change parameter value. Short press to increase or decrease the value. Short press to save the previous change and jump to the next setting.