Advertisement
Installation Instructions
OG03 Bullet Guard on CB-44-3AL Coil Storage Bracket
3
Re-Pressurizing the OG03 Enclosure
1. Remove bullet guard from Opti-Guard splice enclosure.
2. Dismount the Opti-Guard splice enclosure from the studs on the CB-44-3AL coil
storage bracket.
3. Lower the Opti-Guard splice enclosure to a suitable work area, uncoiling the necessary
2
amount of cable to get from the mounting location to work area.
Re-Entering the OG03 Enclosure
1. Follow steps 1-3 in the "Re-Pressurizing the OG03 Enclosure" section.
2. Remove drawer assembly from casing.
4
3. Disassemble drawer assembly to perform necessary repairs or additional splicing.
If additional splicing is required, follow the splicing instructions per installation
instructions provided with Opti-Guard splice enclosure for the specified cable.
4. Follow steps 4-8 in "General Installation Instructions" section.
www.AFLglobal.com or 800-866-7385
1
2
Installation Instructions
INS-ACA129
Opti-Guard Splice Enclosure
with OG03 Bullet Guard installed
© 2020, AFL, all rights reserved. Revision 0, 12.11.2020
Specifications are subject to change without notice.
Advertisement
