Advertisement
4.2.
operating sWitch refer to fig.1
4.2.1.
The switch has three positions: Middle position - power is disconnected, Right hand position (pushed fully through to the right) the
riveter will turn in a anticlockwise direction, Left hand position (pushed fully through to the right) the riveter will turn in a clockwise
direction.
note: make sure the switch is in the middle (off) position before changing puling poles and nosepieces etc.
4.3.
changing pulling poles and nosepieces refer to fig.1
4.3.1.
remove the outer socket by undoing it clocKWise with the spanner supplied.
4.3.2.
Remove the pulling pole installed and remove the four washers (note their position and orientation).
4.3.3.
Use the smaller end of the spanner to undo the nosepiece (turn ANTICLOCKWISE), remove the nosepiece.
4.3.4.
Select the required size of pulling pole and nosepiece, insert the hex end of the pulling pole into the hex socket on the riveter.
4.3.5.
Place the washers onto the pulling pole in the order shown in fig.2.
4.3.6.
refit the outer socket and tighten.
4.3.7.
fit the nosepiece and tighten clocKWise.
4.4.
riveting
4.4.1.
select and install the required pulling pole and nose piece.
4.4.2.
Push the switch to the left.
4.4.3.
screw a rivet nut onto the pulling pole, pull the trigger gently, the pulling pole will rotate into the rivet nut.
4.4.4.
Put the rivet nut into the hole in the metal sheet etc. P
4.4.5.
Pull the trigger until the rivet nut is fixed into the metal sheet.
4.4.6.
Push the switch to the right, gently pull the trigger and the pulling pole will rotate out of the rivet nut.
4.5.
drill
4.5.1.
remove the outer socket and the pulling pole.
4.5.2.
Pull the head cap, see fig.3, forward and insert the drill bit into the drive socket.
4.5.3.
to change the drill bit pull the head cap forward to remove.
4.5.4.
Push the switch through to the left hand side to drill a hole. Push the switch through to the right side to reverse the drill out of the hole.
note: only use the drill bits supplied in the kit.
4.6.
screWdriver/impactdriver
4.6.1.
Pull the head cap forward to insert the desired tool.
4.6.2.
Push the switch through to the left and pull the trigger gently to drive a screw etc. and push the switch through to the right to remove a
screw etc.
recycle unwanted materials instead of disposing of them as waste. all tools, accessories and packaging should be
sorted, taken to a recycling centre and disposed of in a manner which is compatible with the environment.
When the product becomes completely unserviceable and requires disposal, drain off any fluids (if applicable)
into approved containers and dispose of the product and the fluids according to local regulations.
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
important: no liability is accepted for incorrect use of this product.
Warranty: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
© Jack sealey limited
fig.2
environmental protection
sole uK distributor, sealey Group.
Kempson Way, suffolk Business Park,
Bury st. edmunds, suffolk.
iP32 7AR
Original Language Version
01284 757500
01284 703534
cP315 | Issue 1 09/07/15
fig.3
www.sealey.co.uk
Web
sales@sealey.co.uk
Advertisement
