Troubleshooting - Liberty Safe HDX-250 SMART VAULT Manual

HOME DEFENDER SERIES

TROUBLESHOOTING

MOST PROBLEMS OCCUR WHILE OPENING:
- when a finger is not positioned over the sensor in a similar way as it was when it
was originally enrolled. (reprogram the finger print)
- when a finger was dragged or slid over the sensor too quickly when powered only
by battery. The senor must go through a "wake-up" process when the HDX-150
SMART VAULT is powered only by battery. (touch the sensor and pause one
second before swiping your finger)
- when there is too much pressure applied at the front of the finger while dragging
or sliding a finger across the sensor. Uniform pressure is suggested.
- when a finger was dragged or slid over the sensor at too much of an angle. This
may cause the sensor to register an inaccurate reading.
Note: It is important that you practice the sequence several times to make
sure that you have the process correct. Once you have the positioning learned,
the HDX-250 SMART VAULT will open quickly and consistently.
THE HDX-250 SMART VAULT BECOMES INOPERABLE
If the
HDX-250 SMART VAULT
to open the vault's door.
Remove the lock cover to access the Key Lock. Slide or pull back the lock cover ,
insert the key into the lock and turn to release the door catch. The door will open
immediately.
CLEANING YOUR SMART VAULT
CLEANING
To clean the surface of the
and soft cloth only. Avoid getting the sensor area wet.
To clean the sensor area - use a slightly damp and dust free cloth to wipe the
sensor area.
CAUTION: Products that contain ammonia or chlorine if sprayed on the fingerprint
sensor could cause difficulties reading and enrolling fingerprints and could damage
the HDX-250 SMART VAULT's finish.
becomes inoperable, you will need to use your keys
HDX-250 SMART VAULT - u
8
se a mild soap and water