Download Print this page
Living Heat M100 Instruction Manual

Living Heat M100 Instruction Manual

Electrical thermostat

Advertisement

Quick Links

M100 Electrical Thermostat
Thermostat Characteristics :
Mounted on the surface of the wall indoors
Temperature control range +5/+40℃
LED turned on while heating
Satisfying the requirements of safety, energy saving
and comfort.
Types Table:
Load
Types
Current
16A
M100
Technique Parameters:
Voltage: 220VAC
Power consumption: 5VA Temperature
control range: 5~40 ℃ Temperature
limit range: 25~55 ℃ Power save mode
temperature: 5℃
Temperature deviation: ±0.5K
Ambient temperature: -5~50℃
Degree of protection provided by enclosure: IP20
Outer sensor: length of cable 3m
Specification:
Mounting of Outer Sensor:
Please connect the remote sensor to the appropriate terminal
as shown on the diagram, place the sensor cable within the floor
M100
Methods of
Temperature
Applications
Measurement
Heating cable and
Outside Sensor
other power heat loads
supply (e.g. power supply for heating cable) for avoiding the
interference of voltage signal to the heating thermostat. If there is
shielded cable in the extended cable, shielded cable should not be
connected to ground but to terminal 7. It is recommended that the
extended cable and casing should not be shared with others.
Outer sensor and its resistance:
Temperature( ℃)
5
10
20
30
40
Mounting Location Recommended:
The heating thermostat should be mounted on the wall with
air flowing freely around.
Warning: The mounting location should not be influenced by
other heat source (e.g. sunlight), air flow through doors &
windows or temperature of outer wall.
Temperature Set:
The factory default of temperature control range is +5/+40℃.
For convenient adjusting the LED will be turned on while heating.
For the first use, please set the thermostat at the highest temperature,
when the room or floor temperature approaches the expected, please
turn the knob back until the LED is turned off. One or two days after,
user could do fine turning if necessary.
Handling Instruction:
① on and off:
on
off
② temperature set:
5~40℃
③ indicator:
LED turned on while
heating.
Instruction Manual
Resistance(Ω)
22070
17960
12091
8312
5827
30
40
20
10
Floor Heating Thermostat

Advertisement

loading

Summary of Contents for Living Heat M100

  • Page 1 M100 Electrical Thermostat Instruction Manual supply (e.g. power supply for heating cable) for avoiding the interference of voltage signal to the heating thermostat. If there is shielded cable in the extended cable, shielded cable should not be connected to ground but to terminal 7. It is recommended that the extended cable and casing should not be shared with others.
  • Page 2 M100 Electrical Thermostat Instruction Manual channel or conduit and the outer sensor bulb should make contact with the floor to be heated. Floor Heating Thermostat M100...
  • Page 3 M100 Electrical Thermostat Instruction Manual Temperature Calibrating: Figure.3 When indoor temperature reaches steady state, user could calibrate the heating thermostat to make the temperature reading be the same as the real room temperature. Calibrate Operation Procedures: Measure the temperature with thermometer;...