Advertisement
Parts:
1x Reflector body
1x Cable gland
Assembly instructions:
1. Fix the cable gland to the Cooltube flange and pull the cable (min. 3 x 1.5mm
bushing and connect the wire to the lamp.
2. Carefully pull out the lamp holder until it is no longer flush with the Cooltube. Connect the wires to
the socket (see sketch below)
3. The brown wire (live conductor) needs to be connected to the socket contact.
4. The light blue wire (neutral conductor) needs to be connected to the frame contact.
5. The green-yellow wire (earth) needs to be connected to the socket holder hole using a cable eye
M5 1.5-2.5mm
. Note: Pack doesn't include the cable eye nor the screw.
2
6. Push the lamp holder back into the Cooltube until sitting flush. To prevent wiring issues in the
future, pull the cable from the exterior of the Cooltube until the inner wires become taut. Note: The
cable tie is used for safeguard.
7. Peel the covering foil from the reflective aluminium plates off. Insert the reflective aluminium plates
into the flange and secure them with the 2 screws on both sides, by using a hand-held drill machine
with crosshead screwdriver.
Depending on the desired illumination angle, adjust the outside reflector by hand.
Electric installation must be performed in accordance with the national wiring Standards
Manufacturer:
PRIMA KLIMA TRADING CZ s.r.o.
Radnice 594, 33828 Radnice u Rokycan, Czech Republic
Phone: +420 371795340, Fax: +420 371795343, Email: support@primaklima.com, www.primaklima.com
2x Side reflector sheets
4x Cross-head screws 2.2mm x 6.5mm
Warning:
by authorised personnel only.
) through the rubber
2
Advertisement
