Vista Acoustics VW6 Installation Instructions

INSTALLATION INSTRUCTIONS:
Tools Needed:
Pencil
Keyhole or Drywall saw
Phillips screwdriver
Small level
Fish tape or a coat hanger
Wire strippers
Gloves
Safety goggles
Drill
1" Flat bit (if driving through studs ½" or ½" bit for test hole)
1: Decide where you want to place your speakers. The speakers should be
separated approximately 6 to 10 feet apart. If possible, the left and right speakers
should be located the same distance from the listening position. If needed, the piv-
oting tweeter on the VW6 can be directed towards the listener for improved sound
quality.
2: Make sure the place you choose for your in-wall speakers is between the
wall studs. Tap the wall for a hollow sound or use a stud finder to locate the studs.
3: Trace around the cardboard template for your speaker placement as
shown in Figure A. Make sure the speakers are even and level.
4: Drill a small hole in the center outline you just traced.
5: Bend a piece of coat hanger wire. Insert the wire into the hole, then slowly
rotate to check for any obstructions. If there are any obstructions, patch the hole
and relocate the speaker. See figure B.
6: Carefully cut away the outline you traced using a keyhole or drywall saw.
Then remove the cutout. See figure C.
7: Run the cable from the speaker outputs of your receiver or amplifier to
your speakers. Allow a few extra feet of cable. You may also splice together lengths
of cable if you have a long distance to cover. Leave enough cable slack to strip the
conductors and work on the connections.
Note: If cable is to be run through walls or ceilings, the cable must be UL and CL
rated for your safety and building code compliance.
VW6 In-Wall Speaker
VISTA ACOUSTICS VW6 OWNER'S MANUAL
Figure A: Mark cutout area
using template
Drill Hole, Insert Coat Hanger
Figure B: Check clearances
inside the wall
Figure C: Cut speaker hole