Table of Contents
Advertisement
(7) Pull up the presser foot lever to raise the presser bar high enough to allow the
mounted embroidery frame to get onto the feed cover plate. After that, lower the
presser foot lever and commence embroidering (Fig. 25). The speed of shifting the
frame must be coordinated with that of the movement of the needle.
14. DISMOUNTING THE BELT
By moving the belt shifter (Fig. 26) to the left and working the treadle, the belt
disengages the treadle wheel by itself. To replace the belt, only put the belt in the right
and turn the treadle wheel in sewing direction, then work the treadle to enable the belt to
cling to the trough clamp at the rim of the treadle wheel. A couple of revolutions of the
treadle-wheel will bring the belt into place.
15. THE USAGE OF THE HAND ATTACHMENT SET
When a hand attachment is fixed to the sewing machine, it is operated by hand. Being
portable it can be operated on any table. It is best suited for household and traveling use.
Before operation, pull out the crank and fasten its arm (Fig. 27-2) to the fixing pin (Fig.
27-3) made for it. Then push the driving block into one of the spaces of the balance wheel
(Fig. 27-4). Take hold of the crank, turn the wheel smoothly with the right hand in the
direction indicated by the arrow as shown in Fig.27 and start sewing.
Fig. 24
Fig. 26
Fig. 27
Fig. 25
Advertisement
Table of Contents
