Black IC-SLDCP6 Safety precautions To avoid causing harm and property damage to you or others, please carefully read and follow the "Safety Precautions” below. Symbols definition Indicates reminder and warning. Indicates DO NOT. Indicates ALWAYS DO. Danger Improper usage may cause death or serious injury.
Page 3
Black IC-SLDCP6 ● Avoid contact with or use on Use the charger correctly sprays (Pesticides, hairspray, ● Please periodically clean the dust lubricating oil, etc.) from the power plug Prohibited ● Do not use on inflammable substances To prevent dust accumulation causing...
Black IC-SLDCP6 Safety precautions Continued ● Do not continue to run this product ● When unplugging the charger, be when the suction port is blocked sure to hold the charger body, do ● Do not block the air vent...
Black IC-SLDCP6 Section title Body On the back of the body Control panel Magnet section (Wall hanging parts can be used to place the body onto Hand lever the wall.) Charging power interface Battery indicator Battery cover Dust sensor indicator light...
Page 6
Black IC-SLDCP6 Section title Continued ■ Attachment ■ Operation panel(Hand lever) Charger Standard / Turbo mode button Automatic mode button Charging power cord Off (Stop) button Charging plug ■ Display panel(Body) The wall hanging components Dust sensor indicator light...
Black IC-SLDCP6 Preparation ■ Assembling When using the hand-held vacuum cleaner When using an extension tube vacuum • Insert the suction head directly into the body. cleaner ①Insert the extension tube into the body. ②Insert the suction head into the extension tube.
Page 8
Black IC-SLDCP6 Preparation Continued ■ Charging About the battery ● It's not unusual for batteries and chargers ● At the time of purchase, the battery is not to get hot while charging. ● The charging time and usage time will fully charged.
Page 9
Black IC-SLDCP6 ■ How to use the wall hanger ①The wall should be wiped clean before applying the adhesive sheets. ②Tear off the peeling paper on the adhesive sheet, A magnet is built into the back of the body of this stick it on the wall, and press fully.
Page 10
Black IC-SLDCP6 Preparation Continued ■ Tearing off the adhesive Position the body of the vacuum vertically and secure it on the wall hanger sheet • Place the body as close to the wall as possible. When moving or discarding, tear off the adhesive •...
Black IC-SLDCP6 Operation instructions Press the button and select the operating Start cleaning mode Floors, etc. • Start running in the selected mode, and when the • Use the suction head to move slowly forward and suction head is attached to the floor, the built-in backward as it sucks in dirt.
Page 12
Black IC-SLDCP6 Operation instructions Continued ■ Using as a hand-held Remove the dust bag unit vacuum cleaner • Pull it straight up and take it off. Dust bag unit Remove the extension tube to also use the device as a hand-held vacuum cleaner.
Black IC-SLDCP6 Cleaning and maintenance ● When cleaning and Close the dust bag cover maintaining the • Close it forcefully until you hear a click. device, please stop operation, disconnect the power and remove Attention the charger. ● Do not drench the...
Page 14
Black IC-SLDCP6 Cleaning and maintenance Continued Suction head Revolving brush Dirt accumulation When the dirt is obvious • If there is any dirt accumulation in the rotating brush and suction port, please use tweezers to Remove the brush cover clean it.
Page 15
Black IC-SLDCP6 Sponge filter Every three months or so Install a revolving brush ①Insert one side of the brush free gear into the belt Remove the dust bag unit and the opposite rotation shaft. ②Attach the belt to the gear.
Black IC-SLDCP6 Battery replacement method ■ Battery installation method Charge in the correct way. If the use time is still significantly shorter, please replace the battery with a new battery. ■ Battery removal method Connect the new battery to the connector •...
Black IC-SLDCP6 Troubleshooting If something odd occurs during operation, please carefully read this manual before sending for repair, and check if it is one of the causes below. Possible causes Frequent problems Solutions ➡ ➡ ● Please charge with the provided charger.
Page 18
Black IC-SLDCP6 Troubleshooting Continued ● If the indoor temperature of ● Please charge in a place with a room the place where the vacuum is ➡ ➡ temperature of 5℃ -35℃ and no direct charging is too low or too high, sunlight.
Black IC-SLDCP6 Specifications Dust capacity 0.3L 0 〜 40℃ Useable temperature range 5 〜 35℃ Charging temperature range Standard(Approximately) 18 Minutes Turbo mode(Approximately) 8 Minutes Continuous running time ※1 Automatic mode 20-30 Minutes (Varying according to usage) (Approximately) Battery lithium-ion battery...
Page 20
Black IC-SLDCP6 Charging Vacuum Cleaner IC-SLDCP6 Warranty card This warranty card is a certificate for providing free repair according to the following warranty terms in case of failure within the following period from the date of purchase. Date of purchase ※...
Need help?
Do you have a question about the IC-SLDCP6 and is the answer not in the manual?
Questions and answers