Cepex CSP-050 Instructions

Radius
Reduction
Screw
Plus+ Minus-
Arc Adjustment
Arc Adjustment:
(All CSP-050 adjustable heads are PRESET to
approximately 40°)
1. Rotate the nozzle turret counterclockwise to the
left stop.
2. Now, rotate the nozzle turret clockwise to the
right stop. This is the fixed side of the arc. The
nozzle turret must be held in this position for all
arc adjustments.
To increase arc:
1. Insert the key end of the wrench into the
adjustment socket on top of the sprinkler.
2. While holding the nozzle turret at the right stop,
turn the wrench clockwise.
3. Wrench will stop turning when adjusted to the
maximum arc (360°). Do not go past this stop.
4. Adjust to any arc between 40°–360°.
To decrease arc:
1. Insert the key end of the wrench into the
adjustment socket.
2. While holding the nozzle turret at the right stop,
turn the wrench counterclockwise.
FLUIDRA ESPANA, S.A.U.
www.fluidra.es
Pull-up
Socket
SCALE 2:1
3. Wrench will stop turning when adjusted to the
minimum arc (40°). Do not go past this stop.
4. Adjust to any arc between 40°–360°.
Radius Adjustment:
To decrease radius:
1. Turn nozzle-retainer/range-adjustment screw
clockwise using hex end of tool or slot
screwdriver. This can reduce radius up to 25%.
2. If an even smaller radius is desired, install a
smaller nozzle. This will affect precipitation rate.
To increase radius:
1. Turn nozzle-retainer/range-adjustment screw
counterclockwise using hex end of tool or slot
screwdriver.
2. If larger radius is desired, install larger nozzle.
This will affect precipitation rate.
Precipitation Rate Adjustment:
To increase precipitation:
1. Remove existing nozzle.
2. Replace with larger size.
3. Adjust radius.
To decrease precipitation:
1. Remove existing nozzle.
2. Replace with smaller size.
3. Adjust radius.
Note: Undamaged nozzles are reusable.
CSP-050
Gear Driven Sprinklers
P/N 700974 INT-986 12/12