Download Print this page

Englefield VALENCIA Installation Instructions

Led mirrors

INSTRUCTIONS

FURNITURE

1378364-A02-B

25/01/2018

VALENCIA

WARNINGS:

This installation must comply with the most recent AS/NZS 3000

electrical standards.

The light source of this luminaire is not replaceable; when the light

source reaches its end of life the whole luminaire shall be replaced.

1. Fitting instructions are intended to facilitate installation. They are not

subject to contract.

2. Since the type of wall determines the fittings necessary for each unit,

bolts and screws have not been supplied for hanging the mirror but left

to the responsibility of the installer.

LED Mirrors

Englefield

Table of Contents

Do you have a question about the VALENCIA and is the answer not in the manual?

Page 1 INSTALLATION INSTRUCTIONS VALENCIA FURNITURE LED Mirrors WARNINGS: This installation must comply with the most recent AS/NZS 3000 electrical standards. The light source of this luminaire is not replaceable; when the light source reaches its end of life the whole luminaire shall be replaced.
Page 2 In addition to proper installation, read all operating and safety instructions. Prior to installation, inspect your Valencia LED mirror to ensure that no damage has occurred in transit. If damage has occurred, or a visible defect exists, do not proceed with installation, and advise your supplier immediately.
Page 3 VALENCIA LED Mirrors INSTALLATION INSTRUCTIONS INSTALLATION 1. Select an appropriate location to install the mirror where it can be fastened to a nog, and where wiring can be connected without any slack in the wiring. 2. Use a spirit level and refer to the dimensions below to mark the location of the fixing holes with a sharpened pencil.
Page 4 VALENCIA INSTALLATION INSTRUCTIONS LED Mirrors 9. Electrical hard wiring should be connected by a certified electrician, ensuring compliance with AS/NZS 3000 electrical standards are observed. 10. Lift the mirror and carefully lower it onto the cleats. Using the two small screws provided, align the lower bracket and fasten it to the mirror.