Whirlpool AGB 669/WP Manual For Use And Installation page 20

Machine type
1 = brief, continuous wash (maximum 10')
2 = brief, medium, long, continuous wash (maximum 10')
3 = brief and medium wash set to 1
P5
4 = break tank, medium, long and continuous wash
with this configuration the cold rinse option must be set to "0"
5 = with three wash cycles without break tank for top-loading
6 = with three wash cycles with break tank for top-loading
P6 Drain with overflow option
P7 Cold rinse option
P8 Regeneration option
P9 Maximum water load duration
To access the factory menu the following procedure must be followed:
1) Shut the machine off with the
2) Within 6 seconds of machine shutdown press the
At the end of the 6 seconds, the message " P0" will appear on the screen.
3) Select the parameter to modify with the
4) Press the button to view the selected parameter on the display
5) Modify the parameter with the
6) Confirm the modification with the
7) Select, in the same way, other parameters to be modified and modify them as described above
8) After having set all of the machine's parameters, press the
The machine is capable of signaling a series of malfunctions on the display.
If the problem persists after having turned the machine off and then on again, act as indicated below:
E1 Boiler sensor malfunction
E2 Tank sensor malfunction
Water loading timeout ( the water loading duration
E3
has exceeded the time set in P9 )
Draining anomaly. At the end of the draining phase
the CPU still detects water in the Tank. This may
E6
be due to:
30 minute Tank timeout
E7
E8 15 minute boiler timeout
button
button
button
button
7
SCREEN DISPLAYED ANOMALIES
YES/NO
YES/NO
YES/NO
1-10'
button 7 times
button to exit.
Substitute
Substitute
Electrovalve inspection – Verify that the water
faucet is open
Drain pump malfunction
Drain tube blockage
Tank Pressostat malfunction
Drain cycle time ( P0 ) set too low
Inspect the Tank and boiler thermostats
Check for inverted sensors
Inspect the Tank and boiler thermostats
Check for inverted sensors
0 NO
0 NO
0 NO
10
8