Table of Contents
Related Manuals for Fired Up Corporation Adam CO907
Summary of Contents for Fired Up Corporation Adam CO907
- Page 1 E L E C T R I C H E A T E R IMPORTANT: Please be aware that this heater may take a few minutes to heat up due to the nature of the element This product is only suitable for well insulated spaces or occasional use.
-
Page 2: Table Of Contents
Read ALL the instructions before use. These instructions are for your safety. Please read through them thoroughly before use and retain for future reference. Failure to follow them could cause injury and/or property damage. CONTENTS SECTION 01 Cautions 03-04 Important safety information 05-07 Introduction Handling... -
Page 3: Cautions
CAUTIONS DO’S • Read ALL the instructions before using this heater. • Only use this appliance for its intended use as described in this manual. • Always install the product in accordance with this guide. If in doubt obtain expert advice. •... - Page 4 • Never use aerosols or steam cleaners on or around the heater. • Never route the supply cord under carpeting and never cover the cord with throw rugs, runners, etc. Arrange the cord away from traffic areas and where it will not be tripped over.
-
Page 5: Important Safety Information
PLEASE DO NOT OBSTRUCT THE AIR VENTS OF THE HEATER UNIT This appliance has a ‘self resetting’ safety cut out system. To prevent overheating, ensure the air inlets and outlets are not obstructed. If the safety cut-out operates, switch off the heater and allow to fully cool down. - Page 6 IMPORTANT! • This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved.
- Page 7 supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children aged from 3 years and less than 8 years shall not plug in, regulate and clean the appliance or perform user maintenance. •...
-
Page 8: Introduction
INTRODUCTION Thank you for choosing this product. The product is designed to meet the most stringent quality, performance, and safety requirements. This guide aims to improve your understanding and appreciation of your new appliance by providing simple and informative instructions. HANDLING Before continuing any further with the assembly and installation of this heater please read the following:... -
Page 9: Tools Required
TOOLS REQUIRED Crosshead screw driver (Electric screw driver recommended) Electric drill with 6mm masonry bit (required if drilling into stone or brick) A pencil A spirit level IDENTIFICATION (Image for illustrative purposes only) Air vents (out) Glass panel Handle Switches Thermostat Body Air vents (in) -
Page 10: Attaching The Feet
ATTACHING THE FEET Warning: Do not plug in before attaching the feet. Using the 12mm screws supplied, fit each The heater is now ready to use. foot, as illustrated above. SWITCHES There are two switches on the right hand side providing a choice of heat settings. A switch is in the ON position when the side with the markings on (i.e. -
Page 11: Thermostat & Care
THERMOSTAT The thermostat is designed to maintain a comfortable room temperature. To set, switch the heat on and turn the THERMOSTAT to MAX. When the desired temperature is reached, slowly turn the THERMOSTAT towards LOW until the heat turns off. Please note that the appliance can only be switched on when the thermostat setting is higher then the room temperature. -
Page 12: Techincal Parameters
TECHNICAL PARAMETERS L 193/88 Official Journal of the European Union 21.7.2015 Table 2 Information requirements for electric local space heaters EFS0043 Model identifier(s): Item Symbol Value Unit Item Unit Heat output Type of heat input, for electric storage local space heaters only (select one) Nominal heat out... - Page 13 PLUG REPLACEMENT (for product fitted with BS plug) This appliance is supplied with a BS1363 3 pin plug fitted with a 13 Amp fuse. Should the fuse require replacement, it must be replaced with a fuse rated at 13 Amp and approved to BS1362.
-
Page 14: Specification
SPECIFICATION Rated Voltage 220-240V Rated Frequency 50/60Hz Rated Power 1000W Fuse (BS Plug) rating 13 Amp CONFORMITY WITH DIRECTIVES Conforms with relevant European Directives ENVIRONMENTAL PROTECTION For electrical products sold within the European Community. This appliance is labelled in accordance with European Directive 2002/96/EC concerning Waste Electrical and Electronic Equipment (WEEE). -
Page 16: Guarantee & Customer Helpline
This product guarantee does not affect your statutory rights. CUSTOMER HELPLINE 03300 882 069 customer.support@firedupcorporation.com www.adamfires.co.uk Fired Up Corporation Ltd. Fired Up Buildings St Thomas Road www.firedupcorporation.com Huddersfield HD1 3LF United Kingdom...
Need help?
Do you have a question about the Adam CO907 and is the answer not in the manual?
Questions and answers