Thank you for your purchase Thank you for your purchase! We are pleased that you have chosen Sears for your outdoor furniture purchase. We hope that you enjoy the unmatched quality, comfort, and style of your new patio set. Every piece is meticulously considered all the way down to the smallest details, exclusively for you, by our world class design team.
Safety Information SET UP YOUR FURNITURE PROPERLY Ensure that all parts are assembled properly and fully tightened as per the instructions. When placing in the desired location, ensure that all legs are resting on the same surface. You may adjust the footcaps as required to ensure that the item stands in a rigid position.
Page 4
Warranty LIMITED WARRANTY - Continued against separation and tearing for one year from purchase date. Fading and/or discoloration resulting from exposure to the elements, oils, spills, fluids, chemicals, or any other cause is not covered. and workmanship only for one year from purchase date. Umbrella bases (if applicable) are not covered under any circumstance.
Care and Maintenance FRAMES Cleaning - Use mild soap and warm water. Do not use abrasive materials, cleansers or bleach products. Rinse with clean water and dry thoroughly. Maintenance - Periodically clean and dry thoroughly. Be sure to drain any water accumulated inside the frames.
Pre-Assembly PLANNING ASSEMBLY To prevent damage, place all parts on a soft surface during assembly. Remove all protective materials before beginning assembly. It takes about 45 minutes for two people to complete all the assembly. OBSERVE WEIGHT LIMITS The recommended weight limits for the following products are listed below: Deep Seating:300lbs :300lbs/seat Sofa...
Pre-Assembly(continued) Package Contents QUANTITY PART DESCRIPTION RIGHT RAM LEFT RAM Safety Information 1. EVERY BOLT NEEDS TO BE USED WITH A WASHER. 2. DO NOT FULLY TIGHTEN BOLTS UNTIL INDICATED IN STEP 3.
Assembly Instructions Attach back frame to the left leg Attach the back frame screw to the hole in the left arm. Add two bolts(H & I) and washer(J) to the left leg. Use the hex bolt driver(N) to tighten all bolts. SCREW HOLE...
Page 9
Assembly Instructions Attach the seat frame For the seat frame(B), add a washer(J) to bolt(F) and insert a bolt through the hole in the back frame. Repeat procedure for two remaining the holes in left leg. Add a bolt(I) and washer(J) to the left leg. Use the hex bolt driver(N) to tighten all bolts.
Page 10
Assembly Instructions Attaching the left leg Follow step 1 and step 2 to complete the assembly. Use the hex bolt driver(N) to tighten all bolts. Cover all bolts with covers.
Page 11
Pre-Assembly(continued) Package Contents QUANTITY PART DESCRIPTION Safety Information 1. EVERY BOLT NEEDS TO BE USED WITH A WASHER. 2. DO NOT FULLY TIGHTEN BOLTS UNTIL INDICATED IN STEP 2.
Assembly Instructions Attaching back frame to the right leg Attached the back frame screw into the right leg hole. Add two bolts(H & I) and washer(J) to the right leg. Repeat procedure for remaining the left leg. Use the hex bolt driver(N) to tighten all bolts. SCREW HOLE SCREW...
Page 13
Assembly Instructions Attaching the seat frame For the seat frame(B), add a washer(J) to bolt(F) and insert a bolt through the hole in the seat frame. Repeat this procedure for both armrests. Add a bolt(I) and washer(J) to the both side armrest leg. Use the hex bolt driver(N) to tighten all bolts.
Page 14
Pre-Assembly(continued) Package Contents QUANTITY PART DESCRIPTION TABLE TOP LEG CONNECTOR BRACKET TABLE LEG Safety Information 1. EVERY BOLT NEEDS TO BE USED WITH A WASHER. 2. DO NOT FULLY TIGHTEN BOLTS UNTIL INDICATED IN STEP 2.
Assembly Instructions Attaching leg connector bracket to the leg Attach two table leg (C) to the leg connector bracket (B) by using bolt (G) and washer(J). Repeat procedure for the other three side. Use the hex bolt driver(N) to tighten all bolts.
Page 16
Assembly Instructions Attaching the table top Attach a table leg to the table top (A) by using bolt(E) and washer(J). Repeat procedure for the other three legs, Use the hex bolt driver(N) to tighten all bolts. Cover all bolts with covers.
Customer Service CUSTOMER SERVICE DEPT: 1337 TAYLOR FARM ROAD, SUITE 100, VIRGINIA BEACH, VA 23453-3142 FAX: (757) 368-0576 CUSTOMER SERVICE NOT LINE:1-800-416-3511 SERVICE HOUSE: MONDAY-FRIDAY 9:00AM-5:00PM (EASTERN TIME) E-MAIL: customerservice@va-cs.com...
Page 18
Please refer to part numbers when reordering For questions or comments about product: Email: www.agio-usa.com or Call toll-free: 1-800-416-3511...