Advertisement
Quick Links
Advertisement
Related Manuals for Pilot Communications EV Plus+
Summary of Contents for Pilot Communications EV Plus+
- Page 1 Pilot EV Plus+ Quick Installation Guide...
-
Page 2: Tools Required
Tools required Name Remark Philips screwdriver Electric with bit preferred Hex (M5) screwdriver Electric with bit preferred Level – Stainless steel anchors Size M10 Stainless steel bolts M10 to fit the anchors Drill When the anchors are not pre-inserted 63A Type C Circuit Breaker –... - Page 3 Prerequisites This type of installation requires an electrical background. When unpacking contents of the kit, it is crucial to perform a visual check to confirm that none of the parts are damaged or broken. Prior to installation, make sure to disconnect the main circuit breaker (CB). Locate the serial number (S/N) of the device on the stand and confirm that the same serial number is configured in the Chargepoint management system with Pilot EV.
- Page 4 Prerequisites ATTENTION Make sure to always follow your current IET Wiring regulations. The Pilot EV Plus+ installation should only be carried out by a certified installer. The below instructions are a guideline and provided for reference only. You are solely responsible for following all applicable electrical safety procedures, codes, methods, and materials provided as per the instructions below.
- Page 5 Dismantle the access panel Using the Hex screwdriver, unfasten the 10 screws to dismantle the access panel. www.thepilotgroup.co.uk 17/01/2020 / DC1 / Version2...
-
Page 6: Assemble The Stand
Assemble the stand Place the stand on a flat concrete surface with pre-inserted stainless- steel anchors. Using the 4 bolts, tighten the stand. Ensure that the stand is aligned straight. +44 (0) 1606 59 66 22 17/01/2020 / DC1 / Version2 ... -
Page 7: Connect The Cables
Connect the cables Connect the cables according to the diagram: L1 = Brown L2 = Black L3 = Grey Blue PE Earth \ PE \ Ground = Yellow Green Make sure to perform the appropriate PE connection test based on the current edition of the IET Wiring regulations. - Page 8 Assemble the access panel Using the Hex screwdriver, fasten the 10 screws to assemble the access panel. +44 (0) 1606 59 66 22 17/01/2020 / DC1 / Version2 ...
- Page 9 Secure the base cover Make sure that the main circuit breaker (CB) meets with the safety requirements. Using the Phillips screwdriver fasten the 4 screws and secure the base (two parts). www.thepilotgroup.co.uk 17/01/2020 / DC1 / Version2...
-
Page 10: Power Up The Device
Power up the device Switch on the main CB - Circuit Breaker (Switch I). Make sure that both the Pilot EV Plus+ screen and VPOS Touch device are turned on and functional in the idle mode. +44 (0) 1606 59 66 22 17/01/2020 / DC1 / Version2 ... - Page 11 At Pilot Group we supply Energy Management Systems, LED Lighting, Traffic Controls, Technology, and Electric Vehicle Charging solutions. As a privately-owned business that has traded internationally since 1992 from our base in Manchester, we believe in working closely with our customers to form long lasting and mutually beneficial partnerships. At Pilot Group we believe in using technology to make the places we live and work SMART, SAFE and SUSTAINABLE.
Need help?
Do you have a question about the EV Plus+ and is the answer not in the manual?
Questions and answers