Install/Remove Battery Of Remote - LENCO LPJ-500 User Manual

Install/Remove Battery Of Remote

Remove the battery compartment cover on the back of your remote by carefully
sliding to open. The battery cover can then be lifted away. Fit the correct
batteries (not included), referring to the polarity markings. Finally, replace the
cover.
NOTES:
•
Batteries shall not be exposed to excessive heat such as
fire.
•
Be sure to check the correct polarity when installing the batteries
•
Do not mix old and new batteries.
•
Only use type AAA/LR03/UM4 type batteries
•
Do not throw batteries into fire because it may explode. Never try to
recharge a single use battery.
Explanation
10
direct sunlight,