Cleaning And Maintenance - Hausmann DB6107E12 Operator's Manual

CLEANING AND MAINTENANCE

CLEANING AND MAINTENANCE
NOTICE: Below are instructions for servicing
your pole saw. Any servicing not mentioned
below should be done by an authorized service
centre.
CLEANING SAW BODY
WARNING: Unplug pole saw from power source
before servicing. Severe injury or death could
occur from electrical shock or body contact with
moving chain.
WARNING: Cutting edges on chain are sharp.
Use protective gloves when handling chain.
WARNING: When cleaning pole saw body,
Do not submerge pole saw in any liquids.
Do not use products that contain ammonia,
chlorine, or abrasives.
Do not use chlorinated cleaning solvents,
carbon tetrachloride, kerosene, or gasoline.
Keep pole saw body clean. Use a soft cloth
dampened with a mild soap and water solution.
Wipe pole saw body to clean.
STORAGE
If storing pole saw for more than 30 days, follow
steps below.
Remove and clean guide bar and chain. Clean
guide bar and chain by soaking it in petroleum
based solvent or mild soap and water solution.
Dry guide bar and chain.
Place chain in container filled with oil. This will
prevent rust.
Wipe a thin coating of oil over surface of guide
bar.
Wipe off outside of Pole saw body. Do this with
soft cloth dampened with a mild soap and water
solution.
Store Pole saw
• In a high or locked place, out of children's reach
• In a dry place
• With blade cover over guide bar
EN
35