Lehmann electronic VarioRec 6 Quick Reference Manual

®
VARIOREC
Radio Emergency Call Technology
Warning
The use of a call device does not release supervisors from the obligation to supervise the persons supported by such a
device.
This system is radio-based and must therefore not be used for monitoring purposes if life-threatening conditions are
foreseeable. This quick reference guide does not release the user from the obligation to read and understand the contents
of the complete
Note: In this quick reference guide the
This quick reference guide describes only the basic functions. It does not cover failures.
Starting the Radio Receiver and Receiving a Radio Call
1
Power
Supply
Plug in receiver
unit
Before a radio receiver can detect a radio transmitter, the latter has to be programmed in the radio receiver.
1
1
Press and hold the right-hand
button when plugging
5
Briefly press
right-hand
button
*Press the right button while connecting the power supply unit.
Nurse call technologies and personal transmitter technologies
Lehmann Electronic GmbH Niederkassel
Quick Reference Guide
VarioRec 6
Variorec6 manual LE243, available on www.lehmannweb.de
"VarioRec6 radio receiver" is referred to as "radio receiver" or "receiver".
2
Green
Receiver is
operational
Programming a Radio Transmitter
2
Power
Supply unit*
Green
flashing light
Receiver is in
programming mode
6
1.5 s green
The new radio
transmitter has
been programmed
Radio Receiver
3
(transmitters already programmed)
3
7 7
Press and hold
the left-hand
Copyright © 2019 LE235 V1.09 Page 1 von 2
4
Trigger
Receiver indicates and
radio call
Trigger
radio call
button
Phone.: +49 2208 9492 0
1.5 s red
transmits call
4
1.5 s red
New radio
transmitter
has been detected
8
Green
Receiver is
operational again
Fax.: +49 2208 9492 32
www.lehmannweb.de