Page 2
For your safety – Do not mount BeoPort with the cable connections turning downwards. Keep BeoPort away from water and do not place items on top of it. The mains plug enables the separation (switch off) from the net voltage.
BeoPort. This chapter also includes a list of system requirements. Setting up BeoPort, 6–7 Find out how you can set up your BeoPort, what Option number setting is all about, and how to connect the cables. Installing BeoPort, 8–9 Choose between an installation with or without a TV tuner card.
Page 5
1 Make sure that your setup meets the requirements listed below 2 Setup your BeoPort (p. 6) 3 Connect BeoPort (p. 7) 4 Install BeoPort, including TV tuner card and driver (pp. 8–9) 5 Configure BeoPort (p. 10) 6 Register (p. 11)
Beo4 remote control. To be able to remote control your sources via BeoPort, your PC must be turned on. BeoPort – in a Bang & Olufsen system setup Additional Options for the BeoPort box In addition to Option number 6, it is possible to select Option numbers 0, 2 and 4.
Page 7
Beo4 remote control. Mains connection Connect attached products, speakers, your PC and the BeoPort box to the mains. For safety reasons, always connect the BeoPort box (and all your PC equip ment) to a grounded wall outlet.
At the end of the BeoPort installation process you will be prompted to connect the USB cable from the BeoPort box to the PCs USB connector. > Make the USB connection when prompted, not before!
Page 9
> In the Installation menu, select Repair/ upgrade your installation. If the program registers that you already have BeoPort installed on your PC, you will enter the BeoPort Maintenance program. > Select whether you want to repair or upgrade or remove your current installation.
*NOTE! The BeoPort Configuration menu appears automatically when you install BeoPort. To access this menu at a later date, select CONFIG under SETUP on the control bar. To access the On-Screen Guide, select GUIDE in the control bar.
Page 11
Option setting It is important that BeoPort is set to the correct Option, corresponding with your setup. To make an Option number setting… > Select CONFIG to access the menu. > Select the Advanced tab to call up Option settings.
The B&O icon is inserted automatically in the System tray, once the BeoPort application is installed. If you close the application, then start BeoPort from the BeoPort directory in your Start menu, or use the B&O icon short-cut in your System tray.
N.MUSIC is the Bang & Olufsen term for music stored on a PC, music obtained, for example, from the Internet or from audio CD’s. This chapter describes what you need to do, before you can play N.MUSIC. Once you have performed a scan as shown on this page, simply refer to ‘Daily use’...
Registration Register your BeoPort, 11 Scan Scan your PC for tracks, 13 Setup BeoPort in a Bang & Olufsen system setup, Option settings, 6 Placing the BeoPort box, 7 Setup button on the control bar, 12 Sound adjustment Mute, 12...
Page 15
NOTE: This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the...