Summary of Contents for 3M E-Switch
- Page 1 N S T R U C T I O N S Lane Pay Station E-Switch Kit Instructions 75-0302-1496-1 Lane Pay Station E-Switch Kit Instructions - Version 1...
-
Page 2: Warranty Information
3M product in a particular application Given the variety of factors that can affect the use and performance of a 3M product, user is solely responsible for evaluating the 3M product and determining whether it is fit for a particular purpose and suitable for user’s method of application. -
Page 3: Kit Contents
(Figure 1.1). 1 This manual may reference legacy part numbers and product names. Please refer to the 3M Parking Price Book for current product names or contact your customer service representative with questions. - Page 4 Kit Instructions • Lane Pay Station E-Switch Kit Instructions Installing the E-Switch Kit To install the E-Switch kit: Disconnect the Lane Pay Station from the power source. Using the step drill bit, expand the existing button holes to exactly 1.00".
- Page 5 Install the rubber o-ring (included) onto the shaft of the button; snug the o-ring up under the flange (Figure 1.3). Repeat this step for all buttons. 75-0302-1496-1 Lane Pay Station E-Switch Kit Instructions - Version 1...
- Page 6 Kit Instructions • Lane Pay Station E-Switch Kit Instructions Figure 1.3 O-Ring Placement Button hole Switch Hex nut in door Rubber O-Ring Button hole in door Install the buttons into the holes in the door that you drilled in step 2, securing each button with the large hex nut (included).
- Page 7 8, and Table 1.1 on page 8. Figure 1.5 Cable Connections View from back side of Lane Pay Station I/O Cable Jumper Cables White Green Black Black Power Cable 75-0302-1496-1 Lane Pay Station E-Switch Kit Instructions - Version 1...
- Page 8 Kit Instructions • Lane Pay Station E-Switch Kit Instructions Figure 1.6 E-Switch Button Pin Numbering Ring color dot Table 1.1 Wiring Table From Wire Color Cable Lost Button, Pin 3 White I/O Board, J3.4 Receipt Button, Pin 3 Green I/O Board, J3.6 Cancel Button, Pin 3 I/O Board, J3.7...
- Page 9 Modify the programming to reflect the values shown in Table 1.2 on page 9. Table 1.2 Input Configuration Values 3M DEFAULT CURRENT Exit Dev Enab Exit Dev Enab Lost Lost Receipt Receipt Cancel Cancel Coin Vlt Stat Coin Vlt Stat 75-0302-1496-1 Lane Pay Station E-Switch Kit Instructions - Version 1...
- Page 10 Kit Instructions • Lane Pay Station E-Switch Kit Instructions Table 1.2 Input Configuration Values 3M DEFAULT CURRENT Note Vlt Stat Note Vlt Stat Door Open Door Open Apply the button labels under the appropriate buttons, according to the button’s designated function (Figure 1.8).
- Page 11 Lane Pay Station Device Label Sheet Place label 17 over “Change &” when device only accepts credit cards Legacy label - if not already removed from sheet, please dispose label (do not place on equipment) 75-0302-1496-1 Lane Pay Station E-Switch Kit Instructions - Version 1...
- Page 12 Kit Instructions • Lane Pay Station E-Switch Kit Instructions Figure 1.10 Lane Pay Station Label Location Place label 4 only when If the device does not have a card reader, using Validations. place label 10 in this location. If the device has a card reader, see Figure 1.11.
- Page 13 Figure 1.11 Card Reader Label Location If the device has a card reader, place label 9 in this location. If the device does not have a card reader, see Figure 1.10. 75-0302-1496-1 Lane Pay Station E-Switch Kit Instructions - Version 1...
- Page 14 Kit Instructions • Lane Pay Station E-Switch Kit Instructions Lane Pay Station E-Switch Kit Instructions - Version 1 75-0302-1496-1...