juwel DOUBLELOCK Instructions

ELECTRONIC COMBINATION
" DOUBLELOCK "
Prestigious Safes Since 1922
NORMAL MODEL
A) HOW TO OPEN
Press (C), digit the Opening Code (initially 0000) and press (E). If after having pressed (C), ERROR
lights up (see Manipulation Warning in General Notes), you can proceed all the same.
B) HOW TO CLOSE
Press (E). If an obstacle hinders the closing, ERROR blinks and the bolts open
themselves again. Remove the obstacle and press again (E).
C) HOW TO CHANGE THE OPENING CODE
OPEN DOOR, BOLTS WITHDRAWN OUTSIDE THE DOOR (closed lock).
1 - Open (as per point A). OK lights up for 6 sec.
2 - Before OK switches off, press (C) and HOLD PRESSED until CHANGE
lights up.
3 - Digit the New Code (from 3 to 8 digits) and press (E).
4 - Once again, for confirmation press: New Code, (E). OK lights up.
5 - Before closing the door, check the new code (close and open).

GENERAL NOTES

BATTERY - The safes are supplied without battery. The battery-holder lies in the small door placed in
the internal side of the door. The battery consists of 4 ALKALINE LR6 piles of 1,5 V. When the electric
charge goes below a certain level, BATTERY blinks after each opening or closing and it is necessary to
change the piles. However, at least 50 openings are still allowed and, furthermore, there is the
possibility of external energy supply (even in case of completely exhausted piles) by help of a small
cable supplied in the equipment.
ANTIMANIPULATION SHUTDOWN - After 3 attempts to open by wrong codes, the keyboard
switches itself off for 8 minutes, during wich ERROR blinks every 6 sec. An acoustic signal tells you
when you can operate again. But if you try again before 30 minutes have elapsed, then the keyboard
switches itself off again for 8 min. after each wrong attempt (EN and VdS Regulations).
MANIPULATION-WARNING - If by effecting an opening in the right way, ERROR lights up and you
can hear a long sound, this means that at least one manipulation-attempt has occurred since the last
opening .
ELECTRONIC KEYBOARD – Each push-button must be pressed within 15 sec. from the previous one,
otherwise the system switches itself off and you must repeat again from the beginning. In order to
cancel eventual digiting-errors, press (C) (=CLEAR).
JUWEL S.p.A.
Certified EN ISO 9001:2000 - Via I° Maggio 3/E - 20010 - Vanzago (MI) Italy
Tel +39 02/9347441 Fax +39 02/93570804 info@juwel.it www.juwel.it
P.IVA 00692460421
Prohibited partial reproduction also | © Juwel 2009