Safety Instructions - Rebel TOOLS MIE-RB-830 User Manual

SAFETY INSTRUCTIONS

In order to avoid electric shock or other injuries, follow
the safety instructions below:
1. Before using the device, inspect the case for any
mechanical damage. If the case has cracks or is
missing any part, do not use the device.
2. Before using the device, check the test leads for
any insulation damage. If the test leads have
insulation damage or cuts, do not use the device.
3. Do not input voltages higher than those in the
specification.
4. During measurements do not change the
position of the rotary switch.
5. Take extra precaution while measuring voltages
above 60 V DC and 30 V AC.
6. Before measurement position the rotary switch
to correct position and connect the test leads to
the proper terminals.
7. Do not use the device in temperatures
exceeding the range in specification, in high
humidity, and near explosives and flammables.
8. During measurement, hold the test leads by the
finger guards.
9. Before measuring resistance, continuity, diodes
and hFE, disconnect the measured circuit from
power and discharge all capacitors.
10. If the display shows low battery icon, change the
batteries.
measurements may be decreased.
11. Before opening the battery case disconnect the
test leads from measured circuit and from the
device.
12. Spare parts (battery and fuse) must be replaced
for a new ones and with the same specification.
EN
Otherwise
10
the accuracy of