Master equipment TP0129 Quick Manual

TP0129 Bone Shaped Electric Table
• Lifts up to 220 lbs
• 45"L x 25 1/2"W x 1"thick tabletop
• Height adjusts from 16" to 39"
• Heavy-duty steel construction
• Durable, rust-resistant, ivory powder-coated nish
Grooming Arm Assembly Instructions
Parts List:
A.) Grooming Arm Holder (1)
B.) Grooming Arm (1)
C.) Large Washers (4)
D.) Small Washers (4)
E. Screws (4)
1. Connect the Grooming Arm Holder
(A) to Table by lining up the holes
on the Holder with the holes on
the Table. Thread one Large
Washer (C) and one Small
Washer (D) onto each Screw
(E). Tighten Screws to
table.
Table Instructions:
SAVE THESE INSTRUCTIONS • IMPORTANT SAFEGUARDS
Basic safety instructions should be followed when using electrical appliances, including the following:
READ ALL INSTRUCTIONS BEFORE USING.
DESIGNED FOR ANIMAL USE ONLY.
CAUTION: Do not leave an animal on the table unattended. Use a grooming loop to properly restrain animal. Quick-release loops or clips are recom-
mended to prevent injury in case animal accidentally jumps o the table. Do not use a choke-type lead or collar.
WARNING:
To reduce the risk of burns, re, electrical shock, or injury to persons or pets:
1. Do not leave grooming table plugged in when unattended.
2. Do not allow unsupervised children to play near or operate the table.
3. Do not immerse motor in water or other liquids.
4. Unplug table before cleaning or servicing.
5. Use table only for its intended use as described in this manual. Do not use attachments not recommended by the manufacturer.
6. Never operate this grooming table if it has a damaged cord or plug, or if it is not working properly. If table is not working or is
damaged, contact PetEdge Customer Service at 1-800-638-5754.
7. Keep cord away from heated surfaces.
8. Do not place or store this appliance where cord may be damaged by an animal or exposed to weather.
9. Do not pull, twist, or wrap cord around table base. Continuous stress on cord can cause damage and result in a shock hazard.
10. While operating grooming table, keep cord away from moving parts. If cord becomes kinked or tangled, straighten cord and
inspect for damage before resuming use.
OPERATING INSTRUCTIONS:
This table is designed for use with standard 120V outlet. This grooming table also has a polarized plug (one blade is wider than the other). As an
important safety feature, this plug is intended to t into a polarized outlet only one way. If the plug does not t fully in the outlet, reverse the plug. If it
still does not t, contact a quali ed electrician to install the proper outlet. Do not attempt to modify the plug in any way. This table is also designed with
an automatic shut-o . Motor, transformer, and cord are all UL Approved. We recommend that this table be used with a surge protector at all times.
2. Place Grooming Arm (B)
in Holder (A). Use the
knob on Holder to
secure grooming
arm
in place.