Page 5
Caution - Read the operating instructions to reduce the risk of injury. Wear ear-muff s. The impact of noise can cause damage to hearing. Wear a breathing mask. Dust which is injurious to health can be generated when working on wood and other materials.
2.2 Items supplied Important! • Open the packaging and take out the equip- When using the equipment, a few safety pre- ment with care. cautions must be observed to avoid injuries and • Remove the packaging material and any damage. Please read the complete operating packaging and/or transportation braces (if instructions and safety regulations with due care.
4. Technical data Keep the noise emissions and vibrations to a minimum. • Only use appliances which are in perfect wor- Mains voltage: ....... 230 V ~ 50 Hz king order. Power input: ..........1200 W • Service and clean the appliance regularly. Idling speed: ........4500 min •...
6. Operation 5.2 Miter stop (Figure 4/5) • The preset standard angle between the saw 6.1 Working with the hand-held circular saw foot (6) and the saw blade (12) is 90°. You can • c r i r i f .
• 6.2 Using the circular saw Remove the flange (18) and the saw blade • Adjust the cutting depth, cutting angle and (12) in a downwards direction. • parallel stop (see section 5.1, 5.2 and 5.4) Clean the flange and insert the new saw bla- •...
8.4 Ordering replacement parts: Please quote the following data when ordering replacement parts: • Type of machine • Article number of the machine • Identification number of the machine • For our latest prices and information please call 1300 922 271 9.
The guarantee provided in this Guarantee Certificate is given by Einhell Australia Pty Limited ACN 134 632 858 of 6/166 Wellington Street, Collingwood, Victoria (Telephone number 1300 922 271) (Einhell Express Guarantee). CERTIFICATE GUARANTEE Dear Customer, All of our products undergo strict quality checks. In the unlikely event that your device develops a fault, please contact our service department at the address shown on this guarantee certificate.