Advertisement
c. Pairing Go Go Bird with remote control
Your Go Go Bird should already be paired with the remote
control, but if you are experiencing connec�vity issues, please
refer to below pairing steps.
1: Turn on the switch of Go Go Bird and check to see that the
green signal light is on.
2: Place the remote control close to Go Go Bird.
3: Start with remote control off , while holding the top
trigger bu�on and the bo�om
then press on/off bu�on to turn the remote control on (figure 7).
4: Go Go Bird's signal light should be flashing indica�ng that
the pairing was successful.
5: If it fails to match, please repeat above steps.
6:If the remote control is off, Go Go Bird will automa�cally
stop flapping its wings.
Step 1
Figure 7 Buttons for pairing step
bu�on at the same �me,
6
Step 2
Advertisement
