Operating Instructions - Ozark Trail Two Burner Owner's Manual

OPERATING INSTRUCTIONS

PLACE THE STOVE OUTDOORS ON A HARD, LEVEL, NONCOMBUSTIBLE
SURFACE AWAY FROM ANY COMBUSTIBLE MATERIAL. IN WINDY WEATHER,
THE STOVE SHOULD BE LOCATED IN AN OUTDOOR AREA THAT IS
PROTECTED FROM THE WIND. GAS LEAK TESTING PROCEDURE MUST
BE PERFORMED EVERY TIME THE STOVE IS USED.
READ ALL SAFETY WARNINGS AND INSTRUCTIONS CAREFULLY BEFORE
NOTE: Use propane cylinder
upright when possible
to prevent flare-ups.
5
OPERATING YOUR STOVE.
Step 1
Make sure the regulator knob and control knobs are in the "OFF" position.
Step 2
Fully open the propane cylinder valve by turning regulator knob
counter-clockwise.
Step 3
Using a long match, hold the flame beside burner. Turn the control knob
SLOWLY until the burner lights.
WARNING: If the burner does not light within 5 seconds, turn the regulator
knob and control knobs "OFF" immediately. Wait at least
5 minutes until gas fumes have dissipated before attempting to
light burner again.
Step 4
To light the second burner, reduce the flame on the first, lit burner and
repeat Step 3.
Step 5
When food is done, turn stove "OFF". Always turn regulator knob "OFF"
first, then turn the control knobs "OFF".
Step 6
Allow stove to cool completely, then follow instructions in the
"After-Use Safety" and "Proper Care & Maintenance" sections of this
manual.
Burner Control Knobs
Regulator Knob